Installation Instructions; Programme Memory - VISIO TC3-AMP Manual Del Producto

PRODUCT MANUAL TC3-AMP
EN
1 Watts
The most consistent standards for measuring watts are
"Program Power" and "RMS" because these measure average
sustained levels.
Amplifier power output changes depending on how many
loudspeakers are connected. Professional manufacturers
typically quote output based on 8 ohms. Less reputable
manufacturers quote at 4 ohms to make their product seem
more powerful.
This amplifier has an output of:
2 x 25w (sometimes referred to as 50w) @ 8 ohms (two
loudspeakers connected)
2 x 50w (sometimes referred to as 100w) @ 4 ohms (four
loudspeakers connected)
2 Front Panel
1
2
1. Active input indicators (Blue LED)
2. Input 1 3.5mm Minijack socket
3. Volume (rotate) / Input selection (short push) / Standby
(long push)
2
3 Rear Panel
1
1. Power Input (phoenix)
2. Input 2 (ground /left / right)
3. Speaker Outputs
4. Input 1 (ground /left / right)
5. IR receiver
4 IR Remote Control
1
3
2
3
1. Power On / Off
2. Input 1 and 2
3. Volume up and down
4. Mute
Note: the remote is common to other Vision products so some
buttons such as tone do not function with this product.
2

5 Installation Instructions

3
This amplifier module can be fixed as a stand-alone product or
integrated into a Techconnect connectivity faceplate.
Using as a stand-alone product:
1. CONNECT INPUTS If you have a 2-phono cable twist the
4
two ground wires together
2. CONNECT OUTPUTS Connect up to two speakers to each
output (four total)
5
The speaker cable must be unshielded with a gauge of no
less than 0.75mm. THE WARRANTY WILL BE VOID IF YOU
USE UNSUITABLE SHIELDED CABLE E.G. PHONO CABLE.
3. CONNECT POWER
1
4
3
NOTE: THIS IS A LOW-IMPEDANCE AMPLIFIER. DO NOT
ATTEMPT TO CONNECT 100V LINE SPEAKERS (Normally any
speakers with "t" in the part code)
6 Integrating into connectivity faceplate
The example below shows how to connect an adjacent
module. A short cable is included with the amplifier to make
this connection.
2

7 Programme Memory

By default power is turned on the amplifier resumes last input
and volume level.
To change this so that it always comes on at a fixed input and
volume level:
1. With amplifier in standby, press and hold the rotary dial
for 10 seconds. Keep holding it down.
2. After 10 seconds the Input LEDs will flash alternately.
Release the dial when the Input 2 LED is on.
3. Select input and set volume. Long-press the rotary dial to
set amp to standby. This will save the settings to memory.
3