Gb Universal Remote Control 7 In; Insert Batteries - Kopp RM-686 Instrucciones De Uso

GB Universal remote control 7 in 1, RM-686
Instruction manual

Insert batteries

Battery is not included in the package!
Please open the battery cover on the back of the
device - to do this, press the tab down slightly.
Insert two alkaline batteries (1.5 V, AA) into the battery
compartment and close the battery cover again.
Input the code manually
1. Switch on the device to be operated (TV, DVD,
SAT, etc.).
2. Find out the
corresponding brand
code of your device in
the enclosed code list.
Example: your SAT
equipment brand is
"AKAI", and the first
code of the brand is "5010".
3. Press the equipment
button (such as: SAT key),
and the indicator light
will flash.
4. Press the "CODE" button
for two seconds and
release the button when
the indicator light is on
for a long time.
5. Input the found
four-digit code in order
(such as 5010).
Please note:
If the code entered is incorrect, the indicator
flashes three times and then lights up
continuously to indicate that the entry must be
repeated. When the code entry is complete, the
indicator light goes out.
6. Check whether the press operation of the remote
control is normal. If yes - the installation is
successful. If no - please repeat steps 4–6 and
enter other codes of the corresponding brand.
6
SAT CODE
AKAI 5010.5207.5212.5254.
5277.5292.5300
TV/AV CODE
TV DVD SAT
1 2 3
4 5 6
7 8 9
0
TV/AV CODE
-
+
CODE
TV DVD SAT
1 2 3
4 5 6
TV DVD SAT
7 8 9
1 2 3
0
4 5 6
7 8 9
-
0
+
-
+
Clever sein.
Kopp einschalten.
Input the code automaticaly
1. Switch on the device to be operated (TV, DVD,
SAT, etc.).
2. Press the equipment key
(such as: TV key), and the
indicator light will flash.
3. Press the "CODE" button
for two seconds and
release the button when
the indicator light is on
for a long time.
4. Enter the number "1111"
and the indicator light
starts flashing.
5. Place the remote control
at the front of the
equipment you want to
control. The remote
control sends an on/off
signal. After the
equipment is closed,
press "CODE" key within
two seconds and the
indicator light will be off.
6. Check whether the press operation of the remote
control is normal. If yes - the installation is
successful. If no - please repeat steps 3–5.
TV/AV CODE
TV DVD SAT
1 2 3
4 5 6
7 8 9
0
TV/AV CODE
-
+
TV DVD SAT
CODE
1 2 3
4 5 6
7 8 9
TV DVD SAT
1 2 3
0
4 5 6
-
7 8 9
+
0
-
+
OFF
TV/AV CODE
TV DVD SAT
1 2 3
4 5 6
7 8 9
0
-
+
7