Quick Start; Filling / Emptying The Humidifier - THINK GIZMOS TG941 Manual Del Usuario

2.2 Quick Start

• Fill the Humidifier following the Fill Instructions below.
• Connect the USB cable to a compatible USB Plug (not provided).
• Plug the USB-C end of the cable into the slot on the back of the humidifier. When the
power is switched on and connect the humidifier should cycle through the colours and
then the light will turn off.
• Press the button to turn on/off the humidifier.
• Press the button to turn on/off the light.
• Press the button to switch through the light colours. (see below for colour switching
instructions).
• Press and hold the
colours.

2.3 Filling / Emptying the Humidifier

1. Remove the Outer Shell by lifting up the shell whilst holding the base of the Humidifier.
2. Locate the Water Refill Location which is marked with 'Add Water Position'. Fill the
humidifier up to the 'Max Water' line which is marked on the side.
button to switch off the humidifier without cycling through the
Add Water Position
Please Note: Do not overfill the humidifier.
Max Water Line
5