Troubleshooting - m-cro MICRO E-BIKE Traducción Del Manual Original

TROUBLESHOOTING

Problem
Not turning on
The power is on, but the motor does
not move (The operation switch is
displayed, indicating that the remai-
ning battery capacity is sufficient.)
I cannot charge even though the
battery is not fully charged
Running distance is short
EN
54
ebike_V5.indb 54 ebike_V5.indb 54
Please check the device
Is it charging?
Have you applied the brakes?
Are the battery and charging adap-
ter set correctly?
The battery is completely dischar-
ged
Is it charging?
Did you leave the battery without
using it for a long time?
Have you been riding in hilly areas or
on poorly surfaced roads?
Is the temperature too low?
Is the temperature too high?
Are you using a used battery?
Workaround
Please charge the battery. (Refer to
P48 "Battery / Charging method")
Do not apply the brakes when star-
ting. Make sure that the brake lever
is firmly back.
Disconnect the charging connector
from the battery and the power cord
from the charging adapter, and then
reconnect each connector / cord.
(Refer to P48 "Battery / Charging
method")
If the full charge indicator (green
light) appears immediately after
charging starts, there is a possibi-
lity of complete discharge. Please
contact your retailer.
Please charge the battery. (Refer to
P48 "Battery / Charging method")
Even if the battery is fully charged,
it will discharge naturally if it is not
used for a long time, so the remai-
ning capacity may be exhausted.
Travel distance will be shortened
depending on road conditions and
shift position.
Because the battery is cold in winter
and cold regions, the characteristics
of the battery may reduce the capa-
city or shorten the riding distance.
If left at high temperatures, the
battery capacity may decrease.
Battery is reaching the end of its
life. Purchase a new battery and
replace it
2020/7/31 17:39:23 2020/7/31 17:39:23