Contents; Assembly; Prosweep Gear Housing Assembly To - Echo ProSweep 99944200853 Manual Del Operador

8
c
ontents
After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or missing
parts. Use the contents list to check for missing parts.
___ 1 - Brushes / Gear Housing Assembly
___ 1 - Lower Drive Shaft Assembly
___ 1 - Operators Manual
___ 1 - Storage Hook Assembly
a
ssembly
WARNING
Do not perform maintenance or assembly procdures with engine running.
Tools Required: 4 & 5 mm Hex Wrench
Parts Required: ProSweep Gear Housing, Lower Drive Shaft Assembly,
PAS or SRM-SB Power Head w/Shaft & Coupling.
prosweep gear housIng assembly to lower
drIve shaft assembly
1. Remove vinyl caps from attachment drive shaft.
2. Place brush gear housing assembly on a flat surface with gear
housing shaft mount at 45
3. Remove gear housing locator screw (A) with 4 mm hex wrench.
4. Loosen gear housing mounting bolt (B) with 5 mm hex wrench.
5. Position lower drive shaft (end without serial number decal) into
gear housing shaft mount.
6. Align hole in drive shaft housing with gear housing shaft hole
(C) and seat lower drive shaft end into gear housing shaft mount.
Install and tighten locator screw (A).
7. Tighten gear housing mounting bolt (B).
°
angle.
OPERATOR'S MANUAL
MANUEL D'UTILISATION
BEDIENUNGSANLEITUNG
MANUALE ISTRUZIONI
MANUAL DEL OPERADOR
ENGLISH
FRANCAIS
DEUTSCH
ITALIANO
WARNING, SEE OPERATOR'S MANUAL
LÌRE SOÌGNEUSEMENT CE MANUEL AVANT
TOUTE UTÌLÌSATÌON
ACHTUNG! BEDIENUNGSANLEITUNG LESEN
ATTENZIONE, LEGGERE IL MANUALE ISTRUZIONI
LEA Y ENTIENDA EL MANUAL DEL OPERADOR
X770001350
X7702094000
05/09
A
B
C