KitchenAid 27 Manual Del Usuario página 14

6. After the bottom vent shield is installed.
� Align the bottom vent trim tab (B) with the oven frame (A)
as shown.
� Using one #8-18 x 3/8" (9.5 mm) screw (C) on each side of
the bottom vent trim tab (B), align the top of the bottom
vent trim tab (B) to the Hinge receiver (D) as shown.
� Fasten the bottom vent trim securely to the oven frame (A).
B
C
D
A. Oven frame
B. Bottom vent
trim tab
7. Replace the oven racks.
8. Replace the oven door. See the "Replace Oven Door(s)"
section.
9. Check that the door is free to open and close. If it is not,
repeat the removal and installation procedures. See the
"Prepare Built-In Oven" section.
10. Repeat for lower oven door.
IMPORTANT: For proper oven operation, check that the gap
between bottom trim of the door and bottom vent trim is at least
1/4" (6.4 mm).
11. Reconnect power.
12. The display panel will light briefly, and "PF" should appear in
the display.
13. If the display panel does not light, refer the Warranty.
14
A
B
#8-18 x 3/8" (9.5 mm)
C.
screw
Hinge receiver
D.
Positioning Oven Feet
The oven feet need to be installed to allow a microwave/oven
combination to be installed in a recommended cutout height of
42 1 / " (107.9 cm).
2
NOTE: Do not remove the spacers.
1. Using 2 or more people, place the on its back on a covered
surface.
A. Spacers