Plug & Play (Initial Setup) - Samsung HE40A Manual De Usuario

When you turn the TV on for the first time, a sequence of on-screen prompts will assist in configuring basic settings. To turn on
the TV, press the POWERP button.
✎
Plug & Play is available only when the Source is set to TV.
✎
To return to the previous step in the Plug & Play sequence, press the red button on your remote.
1
Selecting the OSD
Language
2
Selecting the usage
mode
3
Setting the Clock
Mode
4
Selecting search
options for auto tuning
5
Selecting and
memorizing channels
6
Setting up the network
connection
7
Enjoy your TV.
If You Want to Reset Plug & Play...
O
MENUm → System → Plug & Play → ENTERE
✎
To change the TV's settings from Store Demo to Home Use when not in Plug &Play, press the volume button on the
TV. When you see the volume in the OSD, press and hold
Plug & Play (Initial Setup)
Press the ◄ or ► button, and then press the ▲ or ▼ button to select
a language. Press ENTERE when done.
Press the ◄ or ► button to select, and then press the ENTERE
button.
y Select the Home Use mode. Store Demo mode is for retail
environments.
Press the ◄ or ► button. Press the ▲ or ▼ button to select Auto or Manual, and then
press ENTERE.
✎
If you selected Auto, you'll select the time zone where you live next, and then select
whether to turn DST (Daylight Savings Time) On or Off.
✎
If you selected Manual, you'll use the number buttons or ▲ or ▼ button to set the
date and time. Use the ◄ or ► button to move between entry fields.
Press the ▲ or ▼ button to select Air or Cable, and then press ENTERE. A check
appears on your selection. Select Next, and then press the ENTERE button. You can
check both if you have both connected.
✎
If you selected Cable, you'll go to the Cable System screen. Use the ▲ or ▼ button
to select Digital or Analog, and then press ENTERE. Use the ▲ or ▼ button to select
the correct cable signal format - STD, HRC, or IRC - and then press ENTERE.
Most cable systems use STD. Select the correct cable signal format for both the
Digital and Analog systems. When done, select Search, and the press ENTERE.
The channel search will start automatically. This can take up to 30 minutes.
For more information, refer to Channel → Auto Program in the e-Manual.
✎
Press the ENTERE button at any time to interrupt the memorization process.
Set up your network connection. Press the ENTERE button to start. If you do not know
your network set up information or want to set it up later, select Watch TV. We suggest
you skip network connection setup now and refer to "Network menu" in the e-Manual for
set up requirements and instructions, and the Network Connection section of this manual
(Page 12). You can set up the network connection later using the Network menu.
Press the ENTERE button.
English - 8
MENU for 5 sec.
POWER
P
SLEEP
FAV.CH
S.MODE