Promaker PRO-TIP20KIT Manual Del Usuario página 9

2nd gear:
High speed range; for drilling with small drilling
diameter.
Temperature Dependent Overload Protection
When using as intended for, the power tool
cannot be subject to overload. When the load
is too high or the allowable battery temperature
range is exceeded, the speed is reduced. The
power tool will not run at full speed until reaching
the allowable battery temperature.
Protection Against Deep Discharging
The lithiumion battery is protected against deep
discharging. When the battery is empty, the
machine is switched off by means of a protective
circuit: The inserted tool no longer rotates.
Working Advice
Apply the power tool to the screw only
when it is switched off . Rotating tool
i
nserts can slip off.
An auxiliary tool can be used to remove the
screwdriver bit or universal bit holder.
Belt Clip
With the belt clip, the machine can be hung onto
a belt. The user has both hands free and the
machine is always at hand.
Maintenance and Service
Maintenance and Cleaning
Before any work on the machine itself (e. g.
maintenance, tool change, etc.) as well as
during transport and storage, remove the
battery from the power tool. There is danger
of injury when unintentionally actuating the On/
Off switch.
• For safe and proper working, always keep
the machine and ventilation slots clean. When
the battery is no longer operative, please refer
to an authorized after sales service agent for
PROMAKER power tools.
®
Dispose of waste
Damaged power tools, batteries, accessories and
waste packaging materials must be recycled and
reused in an environmentally friendly manner.
Do not throw power tools and
accumulators / batteries into general
household waste!
Product serial number interpretation serial
number
No. 17 03
Year Month
The first and second digits of the product serial
number from left to right.
Year of production, the third and fourth digits
indicate the month of production.
The fifth and sixth digits indicate the production
day.
TERMS OF WARRANTY SERVICE
1. This Warranty Certificate is the only
document that confirms your right to
free warranty service.
this certificate, no claims are accepted. In case
of loss or damage, the warranty certificate is not
restored.
2, PROMAKER , through its PX2 warranty
®
for power tools, has the following
characteristics:
It covers the products for 2 years
•
from the date of purchase against
any defect in its operation, for faults
in the materials or labor used in its
manufacture.
• Provides 2 years of free maintenance
service and labor for replacement of
consumables.
Provides a trial period of 2 months
•
where you can exchange the tool for a
higher capacity one if the original does
not meet your requirement, by paying
the difference in price.
• All the attributes offered by the
warranty are valid presenting the
original purchase invoice.
3, Warranty repair is not performed in
the following cases:
- in the absence of a Warranty Certificate and a
Warranty Card or their incorrect execution;
- with failure of both a rotor and a stator of the
electric engine, charring or melting of primary
winding of the welding machine transformer,
charging or starting-charging device, with internal
parts melting, burn down of electronic circuit
boards;
30 03 95
Day
Without presenting
9