Handle Assembly - Snow Joe SUNJOE 24V-X2-21LMSP-CT Manual Del Operador

m
WARNING!
The chargers do not automatically turn
off when the battery is fully charged. Please take care not
to leave the battery plugged into the charger. Switch off or
unplug the charger at the mains when charging is complete.
5. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the
battery.
6. When charging is complete, remove the battery from the
charger by pulling the push lock button and sliding the
battery backward to unlock it from the charger.
Assembly
m
WARNING!
Do not insert the batteries until assembly is
complete. Failure to comply could result in accidental starting
and serious personal injury.
m
WARNING!
Before performing any maintenance,
make sure the batteries and the safety key are removed from
the unit. Failure to heed this warning could result in serious
personal injury.
m
WARNING!
The product must be fully assembled
before operation. Do not use a product that is only partially
assembled or assembled with damaged parts.
NOTE: Before using the mower, follow these instructions to
assemble the handle and grass bag.

Handle Assembly

1. The unit arrives with the handle frame folded down in
storage position. To unfold the handle, press down the
handle latch and flip up the handle frame until the handle
frame clicks into working position (Fig. 4).
Fig. 4
All manuals and user guides at all-guides.com
2. Press down the handle releasing button located on the
Grass Collection Bag Fitting
1. Lift the ejector flap up, and remove the mulching plug
2. With the ejector flap lifted up, hold the grass collection
Handle
frame
Handle
latch
10
middle bar of the handle frame, meanwhile pull the upper
handle frame to extend it to full length (Fig. 5).
Fig. 5
inserted in the rear discharge opening (Fig. 6).
Fig. 6
Ejector flap
bag by the handle and hook the ends of the support rod
on the hooks on both sides (Fig. 7).
Upper handle
frame
Handle
releasing
button
Mulching plug
Rear discharge
opening