Important - Danby DBSH02213WD13 Manual Del Propietário

OPERATING INSTRUCTIONS
INSTRUCTIONS FOR USE
1. Place the heater on a fi rm, level surface. Only use the heater in
an upright position.
2. Pull out the insulating fi lm from the remote control battery
compartment.
3. Ensure the power is turned off.
4. Plug the heater directly into a 120 V AC electrical outlet.
5. Turn the heater on by pressing the power button.
6. Press the mode button to set the desired mode.
7. Press the up and down arrows to set the desired temperature.
The temperature can be set between 15C - 30C (59F - 86F). The
heater will remain on until the set temperature is reached and it
will then cycle on and off to maintain the set temperature.
8. Turn the heater off by pressing the power button. When the
power is turned off the heating element will stop working
immediately but the fan will continue to run for 30 seconds or
until the heater has cooled.

Important

When the heat feature is used for the fi rst time, a slight odor may be
present. This is normal and should not occur again unless the heater
is not used for an extended period of time.
It is normal for the heater to cycle on and off as it maintains the set
temperature.
For the heater to function properly, the set temperature must be
higher than the ambient temperature in the room. If the heater does
not seem to be heating, increase the set temperature to engage the
heating element.
Press and hold the mode button for 3 seconds to change the display
temperature between C and F temperature scales.
9