Winter - Maintenance; Warranty - T.I.P. MTS 5000 UV 7 Instrucciones Para El Manejo

Old UV-C tubes shall not get broken and must not be disposed in regular garbage bin. Contact your local
waste disposal company. Do not use an sharp edged tools. In case Quartz glass cylinder or O-ring are
defect, they should get replaced immediately.
Function check of UVC lamp
In case the UVC lamp does not shine, the micro switch might not be activated. The UVC lamp should get
completely reasembled.
1. Assemble UV-C tube (2) including Quartz glass (3) to lamp socket (1).
2. Make sure O Ring (4) is inserted
3. Pull the protective housing (5) over the UV-C tube and Quartz glass and connect to the socket. By doing
so the micro switch should get active automatically.
The UVC tube works properly if you see a bluish light at the end of the lamp socket (1).
6.3 Cleanting of filter
Replace all filter mats (10) regularly(1 x pro Saison)
If you discover a deteriation of the water quality or too low flow rate or water coming out of the lid of the filter,
the following steps should be done:
1) On the bottom of the filter housing (12) larger amounts of dirt particles get collected over the time.
These must be removed
2) Mechanical sponge filter: Take the sponges (10) out of the filter and clean them with clear water. Insert
the sponges in the correct horizontal positon above the bioballs (11).
3) Biological Filter: the Bioballs (11) should be rinsed out, if the amount of debris has increased strongly
Annual maintenance: Carefully clean the filter at least once per year.
Empty the filter completely. Remove the dirt and debris from the bottom. Rinse out all filter materials with
water.
Winter – maintenance
1.8.

Protect your pond filter from freezing!

If there is danger of freezing, take the pump out of your garden pond.

Completely clean the pump as specified in the instructions.

Store the pump over winter in a frost-free location

7. Warranty

The present device was manufactured and inspected according to the latest methods. The seller warrants for
faultless material and workmanship in accordance with the legal regulations of the country in which the
device was purchased. The warranty period begins with the day of the purchase and is subject to the
provisions below:
Within the period of warranty, all defects which are to be attributable to defective materials or manufacturing
will be eliminated free of charge. Any complaints are to be reported immediately upon their detection.
The warranty claim becomes void in the case of interventions undertaken by the purchaser or by third
parties. Damage resulting from improper handling or operation, incorrect setting-up or storage, inappropriate
connection or installation or Acts of God or other external influences are excluded from warranty.
Parts subject to wear, such as the UV–C tube, rotor and bearings are excepted from the guarantee. All parts
were manufactured using maximum care and high-quality materials and are designed for a long lifecycle. It
should be understood, however, that the wear and tear depends on the kind of use, the intensity of use and
the internals of maintenance. Complying with the installation and maintenance information contained in the
present operating instructions will therefore considerably contribute to a long lifecycle of these wearing parts.
In case of complaints, we reserve the option of repairing or replacing the defective parts or replace the entire
device. Replaced parts will pass into our property.
Claims for liquidated damages are excluded unless they are caused by wilful acts or negligence on the side
of the manufacturer.
The warranty does not provide for any claims beyond those referred to above. The warranty claim has to be
evidenced by the purchaser in the form of the submission of the sales receipt. The present warranty
commitment is valid in the country in which the device was purchased.
6