Rotation direction: summer and winter
The sliding switch controls the direction, whether clockwi-
se or counterclockwise.
Summer option/down - he downwards air current creates
a refreshing effect as indicated in diagram A.
Winter option/up - An ascending air current pushes hot
air away from the fan area near the ceiling, as indicated
in diagram B. This allows you to use less central heating.
14
Balancing – Wobbling problems
during fan operation
If the fan body wobbles during its operation, this is not a
sign of malfunctioning (even if it wobbles a few centime-
ters). To reduce wobbling, you can, while the fan is off:
1. Check that all blades are properly fastened by tighte-
ning their screws.
2. Check the distance between each blade and the cei-
ling. Measurements to the ceiling can be carried out
as shown in the following diagram. If variations exist
and you have already correctly tightened the screws,
check that all blades have the same shape. If any of
them have a shape that is visibly different, this may be
.
causing an imbalance during fan operation
CIF A28763647
If you have completed the previous steps and the wob-
bling has not resolved, you should apply dynamic balan-
cing with the kit provided, as explained below:
1. Turn the fan on to the highest speed so that the greatest
amount of wobbling is produced.
2. Turn off the fan. Select a blade and place a clip on it
(see diagram) halfway between the fastening and the
far edge of the blade.
3. Turn on the fan and check whether the wobbling has
improved or gotten worse. Turn it off once again and
if the wobbling has not improved, place the clip on
another blade. Repeat this process and determine on
which blade it improves the wobbling.
4. Leave the clip on the blade that produces the best re-
sults. Move the clip forward or backwards on this bla-
de until finding the position that offers the best results.
5. Afterwards, remove the clip and place one of the wei-
ghts on the upper part of the center line of the blade
at the position where the clip was located.
+34 916774540
Calle Verano, 51 - Polígono Industrial Las Monjas -28850 Torrejón de Ardoz - Madrid (ESPAÑA)
Maintenance and information of warranty
Maintenance and cleaning:
1. The fan's natural movement can cause certain con-
nections to loosen. Check mounting connections,
fastening parts, and blade accessories twice a year.
Check that they are well fastened.
2. Clean the fan periodically to help maintain its new
appearance. Do not use water to clean it, as this may
damage the motor or the wood, or could cause elec-
trical shock.
3. Use only a soft brush or microfiber cloth as to not
scratch the finish. The veneer is sealed with a layer
of lacquer to minimize discoloration or loss of shine.
4. It is not necessary to oil the fan. The motor contains
bearings with permanent lubrication.
5. Note: Failure to comply with these instructions results
.
in the loss of the equipment warranty
6. Warranty service:
The manufacturer's warranty covers real failures that may
occur but not minor complaints such as the noise genera-
ted by the device, as all electric motors generate a certain
amount of noise.
Operating the fan with slightly loose components (screws
not adequately tightened) or the deformation of blades
due to excessively vigorous cleaning may cause exces-
sive noise and wobbling, which will not be covered by the
warranty. Taking regular care to retighten elements and
clean carefully is enough to prevent these problems.
Control:
The device's warranty will be invalid if it is installed for use
with a solid-state wall switch or dimmer. It must only be
used with the remote control provided with the unit.
Fan installation:
According to the terms and conditions of our warranty, this
fan can only be installed by a certified electrician. Fans
that are installed incorrectly can be dangerous to people
and very expensive to repair, and will lose their warranty.
This fan is designed for interior use only, excluding moist
areas and bathrooms. The supplier does not assume any
liability for physical or bodily damage caused by the in-
correct use or installation of the fan. If you are unsure,
consult an electrician.
Wobbling:
All ceiling fans tend to wobble during their operation. A
wobble of 2 cm is perfectly acceptable and does not indi-
cate any malfunction nor will it cause the fan to fall, as long
as it was mounted to the ceiling correctly following the
instructions in this manual. This ceiling fan has a comple-
tely secure mounting system that uses steel brackets and
connecting spheres to allow it to rotate and to prevent the
transmission of vibrations to the ceiling structure. Please
note that even fans of the same model can have different
wobbles, which is totally acceptable and does not imply
any malfunction or manufacturing defect.
ATC: 916749481 - info@sulion.es / SAT : 916749483 - sat@sulion.es
Increased perception of noise during
nighttime operation:
The manufacturer's warranty does not cover the fact that
during the night, when the surrounding environment is
quieter, the fan's operating noise is more apparent. In ad-
dition, during the night, the power supply may experience
alterations that may produce increased noise generated by
the device, which does not indicate any malfunctioning or
manufacturing defect in the device.
Fan lighthing system:
Noises and vibrations can be greater when the lighting sys-
tem is turned on. For example, the light diffuser can pro-
duce a slight buzz if not adequately attached. Once again,
non-aggressive care and regular check to ensure that all
elements are properly fastened will prevent these distur-
bances. Glass light diffusers are covered by the warranty to
the distributor warehouses, and are subject to verification
during delivery.
Warranty:
The Manufacturer guarantees the correct functioning of the
equipment and possible free repairs or supply of free spare
parts of the model due to manufacturing defects for 3 years
from the date of delivery, 5 years exclusively in the case of
components corresponding to the LED, 5 years exclusively
in the case of AC fan motors and 8 years exclusively in the
case of DC fan motors, but cannot be held liable for dama-
ges and/or losses caused by misuse of the same.
If the Manufacturer chooses to repair the product and
it is not satisfactory or chooses to replace a defecti-
ve product or send a spare part, but is unable to do so
because it is no longer manufactured or available, the
Manufacturer may return to the buyer the amount paid
or replace the product with another comparable pro-
duct (whose design or specifications may vary slightly).
On the other hand, if the Manufacturer, within the 10-year
repair parts maintenance period, is out of stock or no lon-
ger manufactured, the Manufacturer agrees to repair the
product or give the customer a discount on a new or re-
conditioned product of equal or equivalent characteristics.
Warranty terms and conditions: Términos y condiciones de
garantía
https://sulion.es/es/content/12-terminos-y-ga-
rantia
www.sulion.es
15