CRX 1000 Manual Del Operador página 14

The starting position of the
choke will vary depending on
the engine temperature. To start
a cold engine, pull the choke
fully to the "CLOSED" position.
If starting a warm engine, move
the choke to the midway
position between "OPEN" and
"CLOSED".
Move the throttle to the "FAST"
position (if equipped). Turn the
fuel valve to "ON" or "OPEN" (if
equipped).
Turn the key past the "ON"
position to the "START"
position. After the engine has
started release the key allowing
it to return the "ON" position.
If the starter does not start the
engine, do not continue to crank
the engine as damage to the
starter may occur.
Do not try to continuously
crank the engine for more
than five seconds at one time.
If the engine fails to start,
allow the starter to cool one
minute before trying to restart
the engine. Continuously
trying to start the engine will
damage the starter.
If the engine fails to start after
three attempts, verify that the
engine is on a level surface
and the oil level is maintained
at the proper level. Check to
verify the fuel valve is open, (if
equipped).
The engine is equipped with a
low oil sensor; a low oil level
will prevent the engine from
starting.
Routinely inspect the oil level
before each usage of the
engine.
If the engine will not start, allow
it to stop rotating before
attempting to restart the engine.
Should you try to start the
engine while the flywheel is still
rotating may cause damage to
the starter pinion.
10-ENG