Using the heated flat massage head
The heated flat massage head heats up in just 15 seconds, ideal to help
soothe sore muscles.
1. To charge the heated flat massage head, plug the charging cable into a
USB socket and connect the cable to the charging socket on the bottom
of the attachment (fig.5).
2. The charging indicator LED will illuminate and blink red. As soon as the
device is fully charged the LED indicator will change to green.
3. Fit the heated flat massage head to the massager. Press the power
button on the head to switch on the heat, the indicator light will
illuminate green.
4. Press and hold the power on/off/power level button for 2 seconds to turn
the massager on.
5. When you finished using the head, press the power button to switch off
and remove as described in 'Using your device'.
Cleaning your device
• Make sure the device is unplugged from any power supply and allow to
cool before cleaning. Clean only with a soft, slightly damp sponge.
• Never allow water or any other liquid to come into contact with the
appliance.
• Do not immerse in any liquid to clean.
• Never use abrasive cleaners, brushes, glass/furniture polish, paint
thinner, etc to clean.
READ ALL INSTRUCTIONS BEFORE USE. SAVE
THESE INSTRUCTIONS FOR FUTURE REFERENCE.
• The appliance has a heated surface. Persons
insensitive to heat must be careful when
using the appliance
• This appliance can be used by children
aged from 16 years and above and
persons with reduced physical, sensory or
mental capabilities or lack of experience
and knowledge if they have been given
supervision or instruction concerning use of
the appliance in a safe way and understand
the hazards involved. Children shall not
play with the appliance. Cleaning and user
maintenance shall not be made by children
without supervision.
• Do not place or store appliance where it can
fall or be pulled into a bath or sink. Do not
place in or drop into water or other liquid.
• DO NOT reach for an appliance that has fallen
in water or other liquids. Keep dry – DO NOT
operate in wet or moist conditions.
• NEVER insert pins, metallic fasteners or
objects into the appliance or any opening.
• Use this appliance for the intended use
as described in this booklet. DO NOT use
attachments not recommended by HoMedics.
• NEVER operate the appliance if it is not
working properly, if it has been dropped or
damaged, or dropped into water. Return it to
the HoMedics Service Centre for examination
and repair.
GB
3
I