Connection; Testing A Battery And Generator - Powerfix Profi PAWSB 12 A1 Instrucciones De Uso

Danger of chemical burns!
Protect your eyes and skin against chemical burns
caused by acid (sulphuric acid) upon contact with
the battery! Do not look directly at the connected
battery and use the following: acid-resistant safety
glasses, clothing and gloves! If your eyes or skin
come into contact with sulphuric acid, rinse the af-
fected part of the body with plenty of clear running
water and seek immediate medical assistance!
Avoid an electric short-circuit when connecting the
appliance to the battery. Connect the positive pole
terminal clamp only to the positive pole of the battery.
Connect the negative pole terminal clamp only to the
negative pole of the battery.
Connect the terminal clamps (red "+" and black "–")
only to the insulated area!
Attention! Avoid damage caused by
improper use!
Only use the appliance with the included original
parts!
Protect the contact surfaces of the battery.

Connection

First connect the red quick-connect terminal clamp to
the positive pole (+) of the battery.
Then connect the black quick-connect terminal clamp
to the negative pole (-) of the battery.
The appliance can be fastened to the vehicle chassis
during the measurement using the magnetic strip on
the back of the appliance.

Testing a battery and generator

Battery test / start capacity
If only the 11.5 volt LED lights up, the charge of the
battery is weak. The battery must be recharged.
If the 12 volt LED also lights up, the battery is half
charged. Recharging of the battery is recommended.
If the 12.6 volt LED also lights up, the battery is fully
charged and capable of starting.
Attention! Property damage!
charging, learn about how to maintain the battery
by reading its operating instructions!
PAWSB 12 A1
Before
GB │ IE │
9 ■