GENWEC GW07 Manual De Instalación página 9

NOTE 1: For wood studs:
•
If finished wall surface is tile or masonry over wood studs, usea 6 mm (7/32") masonry
bit for the pilot hole until you hit the wood stud, then change to 3.2 mm (1/8") bit.
• Use wood screws, finishing washers and flat washers
NOTE 2: For use with toggle anchors:
• If finished wall surface has wood studs that are not 404 mm (16") on center, has metal studs, or
has an underlying surface of concrete block, use 1/2'' bit.
•
Use machine screws and flat washers
• For holes NOT located in a wood stud, toggle anchors MUST be used
Anchors" section.
6. Align holes in changing station with drilled holes and secure top left corner of changing station to
wall stud using the appropriate screw and washer. Continue to secure the three (3) remaining corners
using the appropriate screws and washers as described in
7. Ensure all four (4) screws are tight and snap caps over screw heads.
WARNING
• All 4 of these locations MUST be used for safe installation. The lower holes ensure installation
through the metal brackets.
Using Toggle Anchors:
1. Insert metal end of toggle anchor into 13 mm (1/2") hole.
2. Slide zip strip down snugly against wall.
3. Snap off break-away pieces of toggle anchor
4. Align holes in changing station with toggle anchors and secure top left corner of changing station
to wall using machine screws and flat washers. Continue to secure the three (3) remaining corners
using machine screws and flat washers.
5.Ensure all four (4) screws are tight and snap caps over screw heads.
Wood stud
D
Break-Away
Instruccions cambiador pañ a les.indd 9
(Fig. B).
(Fig. D).
Toggle anchor
(Fig. A).
(Fig. C). See "Using Toggle
NOTE 1 or NOTE 2.
20/5/19 17:08