Connecting To The Gas Supply - Kingfisher GH60GASLK Manual Del Usuario

EN Connection

01 Connecting to the gas supply

WARNING: THE CONNECTION TO THE GAS SUPPLY MUST ONLY BE
MADE BY A QUALIFIED GAS INSTALLER
• The connection of the hob to the gas pipe network or gas cylinder must be made by means of a rigid
copper or steel pipe with fittings complying with local regulations.
• A connecting elbow is pre-fitted to the hob. This elbow terminates in an external 1/2" BSP connecting
thread complying with ISO 228-1:2003. The connection made to the pre-fitted elbow MUST be suitable
for connecting to this thread. If ANY other connection type or thread size is used a suitable adaptor
MUST be fitted.
• The qualified gas installer must ensure that the operation of the burners has been correctly verified
before use.
02 Adjustment to a different type of gas
CAUTION: Replacement of gas jets must only be carried out by a qualified gas
installer.
NOTE: Extra gas jets are supplied to enable conversion for use with different gas types including liquid
petroleum gas (LPG) butane and propane. Details of the extra jets supplied and their applications can be
found in the Injector Table printed in this manual. These jets must be replaced using a dedicated specialist
tool, not supplied.
CAUTION: The regulation described can only be carried out with burners that
use methane gas and methane/nitrogen blends (where available), and the screw
must be fully tightened in a clockwise direction on burners using LPG.
CAUTION: The Minimum position on the burners MUST be adjusted by a
qualified gas engineer only. Ensure the mains power is disconnected before
proceeding.
5059340445793_MNL_IN_V03.indb 87 5059340445793_MNL_IN_V03.indb 87
87
07-06-2022 14:49:13 07-06-2022 14:49:13