Assembly Of The Appliance - Infiniton HBF-5209 Manual De Usuario

Position the heater so that the heat is directed towards the center of the room and, at

any rate, towards an open space; the front (radiant) part must be at least 2 meters
from curtains, sofas, furniture or other objects.
The appliance should be 1 meter from the side wall.

Do not operate the heater with the gas cylinder outside of its compartment.

The guard of the appliance is to prevent risks of fire or injury from burns and no part of

it should be permanently removed. It doesn't give full protection for young children or
the infirm.
In the event of gas leakage, the appliance gas supply shall be turned off at the gas

cylinder valve.

ASSEMBLY OF THE APPLIANCE

Notes:
 Before assembly, make sure all packing and transit protection material must be
removed.
 After removing the heater from its packaging, check it for damage: if you are unsure, do
not use the appliance and contact qualified service personnel. The packing materials
should not be left within the reach of children because they are potentially dangerous;
dispose of them in conformity with the law.
ASSEMBLY (FIG.1-3)
1. Insert rear base (14) into slots of front base along arrow direction and push on rear base
to fix, then fix rear base into front base using 2pcs M8 screws and washers
2. Attach the tank cover (4) to the slots in the housing side sections.
BATTERY REPLACMENT
Remove impulse ignition cap (9) by turning cap counterclockwise. Install 1 AAA battery.
Negative end of battery goes in first, then replace impulse ignition cap (9) by turning cap
clockwise.
Small deviations may occur. This is not related to quality but subject to improvements.

The appliance must only be powered with LPG gas less than 15-kg cylinder.

The regulator must be EN16129 approved and the hose must be EN16436-1

approved with a length of 50cm.
Connect one end of the hose to the pressure regulator and the other end of the hose

to the tap. Make sure that the connections are tight and there is no damage to any
component or fitting.
Before connecting the cylinder, make sure that its tap is closed and there are no open

flames (lit oven, etc.) in the vicinity and the gasket seal is in good condition. Then
screw the pressure regulator onto the cylinder.
Attach the regulator to the tap, screw the nut tightly counterclockwise.

Carefully check that there is no gas leaking from the connection using soapy water

(one part detergent and three parts water). If there is a leak, bubbles will form; tighten
GB
3