Comedes LTR 100 NEO Manual De Instrucciones página 33

Ocultar thumbs Ver también para LTR 100 NEO:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 73
Drying in the event of construction defects or water damage
In the case of construction defects and water damage, the cause should first be eliminated.
The rooms can then be dried with condensation dryers such as the LTR 100 NEO. The
dehumidifier is operated in continuous operation. The ambient temperature should be at least
20°C (not more than 27°C).
Attention: Only heat the room with water-bearing heating units, such as underfloor heating
and permanently installed radiators.
If this is not possible, the room can be preheated with another electric heater. However, the
dehumidifier must not be located in this room.
The safety and operating instructions in this manual must be followed under all circumstances.
Please note that, depending on the building defect, drying of the insulating layer may also be
necessary.
can become. This must be carried out by a specialist company.
Recommended humidity for rooms
Basically, this depends on the ambient temperature. The higher the temperature of the room,
the lower the relative humidity should be, as otherwise the formation of mould in the room is
favoured. The pleasant humidity ranges from 35% to 65% relative humidity, depending on the
ambient temperature.
The following diagram gives an indication of which air humidity is optimal at which ambient
temperatures.
The diagram assumes that temperatures >=20°C are residential rooms and temperatures
<=20°C are basement rooms.
EN-14
www.comedes.com

Publicidad

Tabla de contenido
loading

Tabla de contenido