EASYHOME HTJ-2108-USBM Manual Del Usuario página 9

− Ensure that the power cable does not come into contact with
hot parts.
− Never expose the product to high temperatures (heaters, etc.)
or to the effects of the weather (rain, etc.).
− Do not expose the product to direct sunlight or hot circulating air.
− Do not use the product with ambient temperatures below
32 °F (0 °C). If the water in the water tank is frozen, wait until it
has melted.
− If the room temperature is below 32 °F (0 °C), empty the water
tank. Freezing water can damage the product.
− Never fill the water tank with water that is above 104 °F (40 °C)
to prevent discoloration or deformation.
− Only put water in the water tank; never put water in the other
parts of the product.
− Never put water into the product's vapor discharge opening or
vapor discharge channel. Wipe wet areas on the product with
a dry cloth.
− Do not put any metals, chemicals, or cleaning agents in the
water tank. Otherwise, humidification won't work properly.
− Never remove residual water from the steam pipe when the
product is switched on. This can destroy the sensor.
− Do not move the product around too much if there is a lot of
water in the water tank. Otherwise, water may leak and can
get into other parts of the product.
− Never attempt to clean the product by immersing it in water,
and do not use a steam cleaner to clean it. Otherwise, the
product could be damaged.
− Do not in any case place the product in the dishwasher. It
would be destroyed as a result.
− Stop using the product if its plastic parts exhibit cracks or
breaks or are deformed. Replace damaged parts only with
corresponding original spare parts.
− Refer to the "Cleaning" chapter.
Safety
9