Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
STEREO MODE
Place the selector located on the rear part of the power amplifier in the STE position.
In this mode, the two channels operate independently. Connect the two loudspeaker inputs and two outputs.
The channel volume is adjusted separately.
R
L
INPUTS
CH B
GND
LIFT
CH A
CH B
BRIDGE MODE
Place the selector located on the rear part of the power amplifier in the BRI position.
In this mode, the input of the two channels will be the channel A input signal. The two power amplifier
channels are connected internally so that their power is combined in one single output. Connect the channel
A input and the loudspeaker BRI output. The volume is adjusted with the CH A control.
INPUTS
CH B
GND
LIFT
CH A
CH B
STE
BRI
PAR
OUTPUTS
(1+, 1-)
BRIDGE
8
ONLY
-
+
STE
BRI
PAR
CH A
CH B
R
STE
BRI
PAR
OUTPUTS
(1+, 1-)
BRIDGE
8
ONLY
-
+
STE
BRI
PAR
CH A
CH B
(1+, 1-) CH A OUT
+
-
SA-204
STEREO POWER AMP.
150 + 150 W RMS, 4
100 + 100 W RMS, 8
200 W RMS BRIDGE 8
(1+,2-) BRIDGE
8
ONLY
CH A
L
(1+, 1-) CH A OUT
+
-
SA-204
STEREO POWER AMP.
150 + 150 W RMS, 4
100 + 100 W RMS, 8
200 W RMS BRIDGE 8
(1+,2-) BRIDGE
8
ONLY
CH A
- 4 -
~115 V AC, 50/60 Hz FUSE: 6.3 A
~230 V AC, 50/60 Hz FUSE: 3.15 A
AC SELECT
POWER CONSUMPTION: 700 W
150 + 150 W RMS@4
100 + 100 W RMS@8
~115 V AC, 50/60 Hz FUSE: 6.3 A
~230 V AC, 50/60 Hz FUSE: 3.15 A
AC SELECT
POWER CONSUMPTION: 700 W
200 W RMS@8
Publicidad
Tabla de contenido
