Initial Operation/Setting; Loading The Fuel Cell; Inserting The Battery; Loading The Nails Into The Magazine - FISCHER FGW 90F Manual De Usuario

6

Initial operation/setting

6.1 Loading the fuel cell

If you are using a new fuel cell, proceed as follows:
For the fuel cell with the Art.No. 553416
remove the safety cap and plug on the
metering valve.
Open the fuel cell compartment cover at the back of the tool. Insert the fuel cell into the
compartment in a way that the metering valve of the fuel cell is facing upwards and fitting into the
red adapter of the tool. Close the fuel cell compartment cover again.

6.2 Inserting the battery

Put the battery into the tool and make sure it is plugged in
correctly. Once the battery has been fitted, the battery-LED status
lights will light up showing the level of capacity of the battery or
the status of the tool.

6.3 Loading the nails into the magazine

Slide the nail strip into the magazine in a way that the nails point
towards the nose piece of the tool. Pay attention to completely
push in the nail strip over the safety clip. Now pull back the push
button until the end of the magazine and release it in a controlled
manner. The push button hooks below the nail strip and pushes
the nails upwards.
Warning: Pay attention to keep your fingers clear off the pathway
of the push button when releasing it, otherwise there is a risk of
finger injury.
For the fuel cell with the Art.No. 538211
just plug on the metering valve.
EN
35