ENG
ORIGINAL
CE DECLARATION CONFORMITY.
Werku
declares that the WK400710 pressure-
®
►
washer is in accordance with the European
Directives and Standards 2006/42/CE,
EN60335-1:2012/A11, EN60335-2-79:2012 and
EN62233:2008.
La Coruña, 01/07/2019
R Yáñez
Werku Tools SA
TECHNICAL CHARACTERISTICS.
Voltage-frequency 230V~50Hz
►
Class I
Protection index IPX5
►
►
Working pressure 80 bar
2900 min
-1
►
pressure 120 bar
Working flow 10.5 l/min
►
Maximum flow 12 l/min
►
50ºC
Net weight 32 kg
►
<70 dB(A)
Vibration Aw <2.5 m/s².
►
PICTOGRAMS.
Attention
Risk of electric shock
Do not connect directly to water mains
Risk of high pressure jet
Read instruction manual
Use eye protection
Use hand protection
Use body protection
Power 2200W
►
Speed rate
►
Maximum
►
-1
Maximum temperature
-1
►
Acoustic pressure LpA
►
European conformity
Double insulation
Waste electrical and electronic equipment
SAFETY INSTRUCTIONS.
Read all security warnings and all instructions
►
Failure to follow all warnings and instructions
►
listed below may result in electrical shock, fire
and/or serious injury
all instructions for future reference
can be avoided in many cases by recognizing a
potentially hazardous situation before it occurs and
by observing appropriate safety procedures
not use this pressure-washer for other applications
than those specified in this manual.
ELECTRIC COMPONENTS.
Danger; risk of electric shock
►
the mains plug and the socket with wet hands
Check the power cord with mains plug for
►
damage prior to every use
damaged power cord replaced by an authorised
customer service / electrician
an appliance if the power cord is damaged
current-conducting parts in the working area must
be protected against jet water
and the coupling of an extension cable must be
watertight and must never lie in water
the coupling may never lie on the ground
use of cable reels that ensure that the sockets are
at least 60 mm above the ground is recommended
Make sure that the power cord or extension
►
cable is not damaged by running over, pinching,
dragging or the like
heat, oil, and sharp edges
and remove the mains plug prior to any care and
maintenance works
the electrical components may only be performed
by an authorised customer service
appliance may only be connected to an electric
supply that has been installed by an electrician in
accordance with IEC 60364
only be connected to alternating current
voltage must correspond with the type plate of the
2
English
Keep all warnings and
►
Accidents
►
Never touch
►
Immediately have
►
Do not operate
►
The mains plug
►
Moreover,
►
Protect the power cords from
►
Turn off the appliance
►
Repair work and work on
►
Warning; the
►
The appliance may
►
►
Do
►
All
►
The
►
The