O P E R AT I O N I NST R U CT I ON
1. Tear the lable from the bottle.
2. Vertically insert the bottle into the bottle supporter on top of the
machine. Dont't plug the power cord or push the red switch until
water runs out from the tap of hot water.
3. Insert the plug to socket, then turn on the power switch. Indicators
light up accordingly once the machine works.
4. Vertically pull out the bottle by two hands when the bottle is empty,
then replace it with another bottle of water.
5. This appliance should work under environment of temp from 10 ℃ ~43 ℃.
6. This appliance is not suitable for installation in an area where a water jet could be
used.
CAU T I ON
1. Keep this machine in place of dry and avoid direct sunshine. Rear
of the machine should be at least 25 cm far from the wall. Never put
the machine on paper or foam, which may cause unstable condition.
Never put anything flammable beside this machine.
2. To avoid damage to the machine, don´t plug the power cord or turn
on the heating switch until water runs out from the tap of hot water.
3. In case hot (or cold) water is not needed for a long time, turn off
the switch accordingly to save power.
English-4