Gescasi remock CODE Guia De Inicio Rapido página 13

Programming of the device with the Smart Lock
Please kindly refer to the following steps to pair the device.
1: Insert new controller from the motorized cylinder Remock MAGIC
If you touch the menu button in the upper right corner when the application is connected to the
motorized cylinder as a master control, you will reach the configuration menu.
In the bottom bar, tap the third icon from the left (Users) and go to Enroll new controller,
tap the green "+" button. After touching the button it will emit a long warning tone (5 seconds) and
a short tone. After that tone, immediately proceed to the next section.
2: Programming of the Remock CODE wireless panel
Press the "0" button and release it, then press the "#" button and hold it for 2 seconds, if the
match is successful, you will hear two tones from the cylinder and the wireless panel will be a
new controller.
More information: https://remock.io/remock-code-manual/