YAT YT5452 Instrucciones De Montaje, Utilización Y Mantenimiento página 51

Problem
Product does not start
EN
Shredding material is not cut
cleanly
Excessive vibration or noise
Recycling and disposal
This product is equipped with the sign of the separated collection and sorting of waste
electricaland electronic equipment (WEEE). This means, when processing and dismantling such
aproduct must comply with the requirements of European Directive 2012/19/EU, to reduce
thenegative impact on the environment.
For more information, contact your local or regional authorities.Electronic products that have
not been separately collected and sorted can be dangerous forthe environment and human
health due to the presence of harmful substances.
TROUBLE SHOOTING
Possible cause
• Not connected to power supply
• Power cord or plug is defective
• Other electrical defect to the
product
• Overload protection is activated
• The blade guard is not fixed
properly.
• Counter blade is not properly
adjusted
• Blade is damaged
• Blade blocked
• Bolts/knobs are loose
50
Solution
• Connect to power supply
• Check by a specialist electrician
• Check by a specialist electrician
• Wait until the product cools
down and press the "ON"
button.
• Fix the guard correctly
• Adjust the counter blade
• Have the blade replaced by a
certified agent
• Remove the blockage
• Tighten the bolts/knobs