Cleaning, Care & Maintenance; Replacing The Interior Lamp - Buffalo CW146 Manual De Instrucciones

Cleaning, Care & Maintenance
• Switch off and disconnect the appliance from the power supply. Allow to cool down
before cleaning.
• Withdraw the door for ease of cleaning.
• Clean the interior of the appliance as often as possible.
• Use warm, soapy water and a damp cloth to clean the appliance.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Always wipe dry after cleaning.

Replacing the Interior Lamp

Call your BUFFALO dealer or a qualified electrician. The Lamp Assembly is available to purchase as a
spare part.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
The unit is not The unit is not switched on
working
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Poor heating effect Poor ventilation
Door is opened frequently or not
shut properly
Food too cold or too much food in
the appliance
Temperature improperly set
Loud noises The appliance has not been installed
in a level or stable position
The appliance is too close to a wall
or other object
Odour from the unit Unit is not cleaned for long time
The lamp does not Lamp needs replacing
illuminate
Light not turned on
CW146_ML_A5_v4_20221031.indb 5 CW146_ML_A5_v4_20221031.indb 5
Probable Cause Solution
Check the unit is plugged in correctly and
switched on
Replace Plug or lead
Replace the fuse
Check mains power supply
Increase ventilation
Check door is hooked in place.
Remove excessive food
Re-set the temperature
Check installation position and change if
necessary
Move to a well-ventilated position
Clean the unit thoroughly
Consult a qualified technician
Ensure button has been pressed properly
EN
5
2022/10/31 11:22 2022/10/31 11:22