Removing The Unit - Kenmore KDC-X305 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation/Connection
Installing the unit (without mounting sleeve)
1
Remove the mounting sleeve and trim plate from the unit.
2
Align the holes in the unit (on both sides) with the vehicle mounting
bracket and secure the unit with screws (supplied/commercially
available).
Use only the specified screws. Using wrong screws might damage the
unit.

Removing the unit

1
Detach the faceplate.
2
Fit the catch pin on the extraction keys into the holes on both sides of
the trim plate, then pull it out.
3
Insert the extraction keys deeply into the slots on each side, then
follow the arrows as shown on the illustration.
Connect external components
No
Part
1
Expansion port (12 V
500 mA):
To the optional SiriusXM Vehicle Tuner (commercially available) (Page 10)
2
Microphone input jack (Page 14)
3
Output terminals
REAR: Rear output
FRONT: Front output
SW: Subwoofer output
• When connecting an external amplifier to the output terminals of this unit, securely
connect the amplifier ground wire to the car chassis to prevent damage to the unit.
29
ENGLISH

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Kdc-bt382uKdc-bt35

Tabla de contenido