Scott Living HDSLFP48L-2A Instrucciones De Montaje página 16

Assembly (continued)
23
Putting paper stickers and stick bumpers
□
Put the paper stickers (MM) onto the cam locks to conceal the cams.
□
Stick the rubber bumpers (PP) on the outer corners of doors where the lower partition panels (S and T) are in
contact with.
24
Attaching upright arms
IMPORTANT NOTE: Use hand screwdriver, not power driver to assemble fireplace insert. See BILT for video
instructions.
□
See figure A: Fasten upper 2 screws (AA) through the upright arm (C) into the heater (A) until tight.
□
See figure B: Fasten lower 2 screws (AA) into the upright arm (C) until tight.
□
Fully tighten all 4 screws (AA) one final time.
□
Repeat the same process with upright arm (B).
WARNING: Do not lift or transport the heater by using the upright arms.
C
AA
K
V
A
AA
MM
W
PP
B
A
C
PP
C
A
AA