Ryobi PCL600 Manual Del Operador página 6

USING THE USB DEDICATED CHARGING
PORT
See Figure 2, page 8.
The USB dedicated charging port provides charging power
of 5 Volts DC at up to 2 Amp for your cell phone, MP3 player,
or other USB devices.
NOTICE:
Attempting to charge devices rated more than 2 Amp,
such as a tablet, could damage the USB dedicated charg-
ing port and/or the device.
 Connect one end of a USB cable (not provided) to your
USB device.
 Connect the other end of the USB cable (not provided) to
the USB dedicated charging port to begin charging the
device.
NOTE: The USB dedicated charging port provides
power only; it does not provide any data communication
capabilities.
MENU NAVIGATION BUTTONS
See Figure 3, page 8.
Use the menu navigation buttons to turn the radio on and
off, control the volume, change frequencies, toggle between
modes and set the time.
TURNING THE RADIO ON AND OFF:
 Press the POWER/MODE button for a half second to
turn the product on.
 Press and hold the POWER/MODE button for two sec-
onds to turn the product off.
NOTE: Pressing the POWER/MODE button also rotates
through the modes.
ADJUSTING THE VOLUME:
When the product is turned on or when the battery pack is
removed and replaced, the radio should return to its previ-
ous volume setting.
 To increase the volume: press the VOL UP button.
Volume settings can be adjusted from 0 – 16.
 To decrease the volume: press the VOL DOWN button.
NOTE: To change volume quickly, hold the VOL UP or VOL
DOWN button.
NOTICE:
Do not use the speaker at maximum volume for an
extended period of time. It could cause damage to the
speakers and/or amplifiers in your unit.
OPERATION
MODE SELECTION:
Press the POWER/MODE button to cycle through available
modes:
 Bluetooth
 FM mode
NOTE: When turned on, the radio will return to the last mode
that was used if the battery was not disconnected. In the
event power is lost to the radio, the display will default to
FM mode.
FM TUNING:
The TUNE/SEEK left and right arrow buttons are used to
tune to the desired radio frequency. The selected frequency
is displayed on the LCD.
 Briefly press either button (not press and hold) to tune
one frequency step at a time.
 To SEEK, press and hold desired arrow button for 1 sec-
ond to tune to the next frequency with clear reception.
STORING A PRESET IN MEMORY:
The memory feature saves up to 10 frequencies as presets
in the product's memory.
To store a frequency in memory:
 Tune to the frequency you want to save.
 Press and hold the PRESET button. A memory location
number will blink on and off.
 Press the TUNE/SEEK button to select a memory location.
 Press the PRESET button to store the frequency in the
selected memory location.
To recall a preset frequency:
 Press the PRESET button and quickly release to cycle
through stored frequencies.
USING A BLUETOOTH
(NOT INCLUDED) WITH THE RADIO
See Figures 4 - 5, page 9.
 Press the POWER/MODE button until the BLUETOOTH
screen appears.
 When the radio is switched to BLUETOOTH
unit will attempt to pair to a BLUETOOTH
and "bt" will flash in the LCD display.
NOTE: The radio will automatically attempt to connect
to the last device it was paired to. If a connection cannot
be established within five seconds, the radio will make
itself available to other BLUETOOTH
 BLUETOOTH
the radio and set to search/scan in order to pair with the
radio.
6 — English
mode
®
ENABLED DEVICE
®
enabled devices must be within 30 ft. of
®
®
mode, the
®
enabled device
®
enabled devices.
®