Maintenance; General Maintenance - Ryobi PCL600 Manual Del Operador

 Select "RYOBI Compact Radio" from your device's list
of available BLUETOOTH
the radio. No password or PIN is required for connection.
 When the device has successfully paired with the radio,
"bt" will stop flashing.
NOTE: When a device is paired to the radio, information for
connecting to the device is saved in the radio's memory.
 Once the speaker has paired with a Bluetooth
device, playback can be paused/played using the PLAY/
PAUSE button.
 When streaming audio from a BLUETOOTH
device, press the TUNE/SEEK left and right arrow but-
tons to go to the previous or next track. Briefly press
WARNING:
When servicing, use only identical replacement parts.
Use of any other part could create a hazard or cause
product damage.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and can be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
NOTE: ILLUSTRATIONS START ON PAGE 8
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
OPERATION
signals to pair the device and
®
capable
®
enabled
®

MAINTENANCE

and release the PLAY/PAUSE button to cycle between
pausing and playing the audio.
NOTE: These controls may not be supported by the
BLUETOOTH
 All BLUETOOTH
normally while paired to the radio.
NOTE: Volume for any device paired to the radio can be
adjusted using the volume control for that device or by
using the radio's VOL + or VOL – button.
 To disconnect the BLUETOOTH
and hold the PLAY/PAUSE button. When the device is
disconnected, "bt" will begin flashing in the LCD display
and the radio will begin searching for another device.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal
injury.
7 — English
device and/or application you are using.
®
enabled device controls can be used
®
enabled device, press
®