Technical Support:
servicio.tecnico@helvex.com.mx
Herramienta Requerida / Required Tools
perico
llave inglesa
adjustable
wrench
wrench
Instalación General
/ General Installation
1
Cierre el suministro de agua.
Ubique y cierre las válvulas de suministro de agua.
Generalmente se encuentran debajo del lavabo. Si se trata de un
reemplazo de grifo, quite el grifo viejo y limpie completamente la
superficie del lavabo.
Locate and close the water supply valve.
Usually found under the sink. If it is a replacement faucet, remove
the old faucet and clean the entire surface of the sink.
INSTALLATION GUIDE
01800 909 2020
01(55)53339431
Thank you for choosing HELVEX products.
We are confident that the product reliability will exceed your highest expectations. The functionality,
aesthetics, durability are at its highest quality! The comprehensive support will grant full satisfaction for years,
reflecting our commitment to quality, innovation and the environment as part of Helvex.
To reduce the risk of injury or property damage, read all instructions. Before installing the product, please
remember to use safety glasses. In construction, installation, alteration, extension and repair, the rules of
constructions must be applied.
As result of continuous improvement, the product illustration may change in appearance.
This installartion guide applies to the product in any finish.
Relation
Installation Requirements
Para el correcto funcionamiento de
este producto, la presión mínima
es de (1.4 kg/cm²) 20 PSI.
For the correct operation of this
product, the minimum pressure is
(1.4 kg/cm²) 20 PSI.
teflón
teflon
tape
/ Close the water supply.
Original Parts:
refacciones@helvex.com.mx
WARNING
Herramienta Incluida en su Producto
/ Tools Included in your Product
Caliente
hot
válvulas
angulares
angle valves
NPT
(Nivel de Piso Terminado)
(Finished Floor Level)
1-02-2928-2
UE-943 Century
Tall Single Handle Batrhoom Sink Faucet
Max. flow rate 1.2 gpm
01 800 890 0594
01 (55) 53 33 94 00
53 33 94 21
Ext. 5068, 5815 y 5913
llave allen
llave de
5/64"
mantenimiento
5/64" allen
maintenance tool
wrench
Fría
cold
*55 cm
(21,6")
*20,3 cm
(8")
*Medidas Recomendadas
*Recommended