Descargar Imprimir esta página

Titanium 516XCD Manual Del Usuario página 10

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Paper jam and motor overload
516XCD is equipped with a motor overload or overheating protection system.
The power supply will end in the following abnormal situations:
1. in case of introduction of the maximum capacity of 16 sheets for a prolonged
period;
2. if introduced above the maximum capacity of 16 sheets at a time or if the
paper is not inserted correctly into the slot.
A jam could trigger the motor overload protection system resulting in an inter-
ruption of the shredder power supply. Never leave the shredder turned on in a
jamming condition.
In case of little paper jammed
1. Taking care not to put your fingers near the sheet opening, grasp the excess
paper and pull it out by placing the switch on INDIETRO (reverse).
2. Make sure that all excess paper has been removed and turn the switch back
to the AUTO ACCENSIONE position.
3. In this way it will be possible to proceed again with the fragmentation of the
documents.
In the event of a major jam
1. Turn off the shredder or unplug it. Wait at least 40 minutes to reset the
overheat protection system.
2. Reconnect the plug. Open the top cover and set the switch to AUTO ACCEN-
SIONE. If there is paper in the mouthpiece, set the switch to INDIETRO (rever-
se) and remove the excess paper paying attention to the fingers. Reposition
the switch to AUTO.
3. In this way it will be possible to proceed again with the fragmentation of the
documents.
8

Publicidad

loading

Productos relacionados para Titanium 516XCD