Publicidad
Idiomas disponibles
Idiomas disponibles
EN | Placing an engine on the trolley
WARNING!
Read these instructions to ensure safe mounting of the
outboard engine
Note: it is possible to use the outboard trolley as a single person.
The TX-65 outboard motor trolley is ready for mounting an outboard
engine after being fully assembled and set up for your outboard engine.
To mount an outboard engine onto the trolley, please read the following
steps carefully.
Make sure that:
- the wheels are set to the maximum width and the knobs are turned
tight
- the tube with the bracket is down so that the bracket rests on the frame
- the knob of the horizontal tube is tight
Step 1.
Lift the outboard engine about 10 cm high and place the tail of
the outboard engine in the tail-support. Use 2 hands!
10 cm.
7
Publicidad
