Setup - Truper SOP-E45 Manual

Assembly of the grinding machine
• Make sure that the grinder is switched
CAUTION
off during the assembly process.
• Fix the angle grinder (A) between the swivel arms (B)
with the two sets of screws and nuts (C) suitable for the
diameter of the holes in the grinding head (M6, M8 or
M10).
• Once the screws have been assembled, tighten them
sufficiently so that the grinder does not move freely.
• Make sure to place the screws with
CAUTION
bushing as shown in picture 1; only in this way you will
obtain the proper tightening on the grinder.
Swivel
arm
Screw
Nut
• Using a screwdriver, turn both leveling screws (D) until
they make contact with the grinder body.
• Adjust the leveling screws to ensure that the cut-off
wheel is at 90° to the base. Use a square (E) to make this
adjustment.
• To ensure that the grinder is properly
CAUTION
mounted, the two leveling screws must make firm contact
in the body of the grinder.
• Once the disc is adjusted to 90°, tighten all the swing
arm screws and the leveling screws to prevent the grinder
from moving.
• Using the square, check that the disc (F) is aligned to the
center of the groove (G) of the iron base. Or lower the
lever (H) to verify that the disc passes through the slot and
does not contact the iron base.
• If the disc does contact the iron base, loosen the two
screws on the movable body (I) and turn it to the left or
right until the disc is aligned with the groove.
J
L
8
ENGLISH
C
Bushing
1
H
D
2
I
• Place the guard shaft (J) in the rear hole of the moving
body and secure it by tightening the screw (K).
• To prevent movement of the guard (J) tighten the two
parallel screws (L).
K
• Connect the grinder, turn it on for a few seconds and
turn it off. Check that all screws, nuts and bolts of the
assembly are tight..

Setup

A
B
D
1
G
F
E