Tabla de contenido

Publicidad

Problem
Cause
Vacuum cleaner does
• Low battery.
not work
• The battery has overheated.
• Switch is in the off position.
• Battery not inserted correctly.
Dust comes out of the
• Filter is not installed or is damaged.
engine vents
• The filter was not installed properly.
• The lip seal of the dust compartment lid
was damaged.
Reduced machine
• The filter is dirty or wet.
efficiency (motor
vibration, low motor
suction)
• There is a blockage in any of the nozzles,
adapter or extension.
The dust is scapes
• It is normal for some dust to escape
from the dust
through the dust trap depending on how
container
the machine is transported.
• Damaged or punctured dust trap.
Battery is leaking
• Tiny drips may occur in extreme
temperatures or after heavy use. This is
normal.
• Damaged battery.
Battery does not
• Charger connection incorrectly
charge and charge
installed on the battery.
level indicator light
does not turn on
• Charger incorrectly connected to the
socket.
• Damaged battery.
If problems persist despite performing the recommended corrective actions,
ENGLISH
10
contact a

Troubleshooting

Solution
• Check that the battery has an adequate charge level,
otherwise charge it.
• Let the machine rest for a few minutes and try again.
• Turn the switch to on, in case the machine does not
start take it to a
Center.
• Remove the battery and make sure it is inserted
correctly by inserting it into the vacuum cleaner's
receptacle until it clicks.
• Install or replace the filter.
• Assemble the filter according to the assembly section
on page 7.
• Take the machine to a
Service Center.
• Remove the filter and clean it as described in the filter
cleaning section on page 7. Do not install the filter until it
is completely dry.
• Replace the filter with a new one.
• Check the accessories, if any object obstructs the air
flow, remove it.
• Transport the machine horizontally after cleaning to
avoid dust leakage.
• Take the machine to a
Service Center.
• Immediately clean liquid from skin and/or clothing with
soap and water.
• Replace battery.
• Insert the battery correctly into the charger.
• Check that the charger plug is properly connected to
the socket.
• Replace the battery with a new one.
Authorized Service Center.
Authorized Service
Authorized
Authorized

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

102446

Tabla de contenido