Sauder Boulevard Cafe Serie Instrucciones De Montaje página 12

Step 8
IMPORTANT: Be sure to keep SCREWS (32) separate from SCREWS (33). Do not confuse these SCREWS.
å
Separate the EXTENSION SLIDES (21) from the EXTENSION RAILS (20) as shown in the upper diagram below. Be
å
prepared, the parts are greasy.
Fasten the EXTENSION RAILS (20) to the ENDS (S and T) and UPRIGHTS (U and V). Use twelve LARGE BLACK
å
1/2" FLAT HEAD SCREWS (32).
NOTE: For each EXTENSION RAIL, turn a SCREW into the 1
å
cartridge of the EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the END/UPRIGHT. Turn a
SCREW into this hole.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
Push the black lever up and
pull the SLIDE from the RAIL.
LARGE BLACK 1/2" FLAT HEAD SCREW
(12 used in this step)
Page 12
21
Open end
32
U
S
20
www.sauder.com/service
st hole shown in the diagram. Then, slide the inner
st
1 hole
V
1
20
T
20
Open end
st
hole
420701