7/ Troubleshooting; 8/ Warranty And Limitations Of Liability - Selecline 600103364 Manual De Utilización

CABINET AND DRUM CLEANING
WARNING! Disconnect the tumble dryer from the mains electricity supply.
EN
• Clean the housing, control panel, and door seal with a slightly damp cloth and a mild detergent
or soapy water. After cleaning, dry all parts with a soft cloth.
• The drum and other stainless steel parts can be cleaned with a suitable stainless steel cleaner
following the manufacturer's instructions.
• Do not use solvents, abrasive cleaners, glass cleaners, or all-purpose cleaners. These could
damage plastic surfaces and other parts.
• The tumble dryer must never be hosed down.

7/ TROUBLESHOOTING

With the help of the following notes minor faults in the performance of the appliance, some of which may result from incorrect
operation, can be put right without contacting the Service Centre.
Repair work to electrical appliances should only be carried out by a suitably qualified person in strict accordance with current
local and national safety regulations. Repairs and other work by unqualified persons could be dangerous. The manufacturer
cannot be held liable for unauthorized work.
Problem
The tumble dryer does not
start.
A hot or burning smell is
coming from the appliance.
The clothes are too dry.
Clothes shrink
Pilling in clothes
• Heavy, wet clothes rotating and hitting the walls of the tumble dryer will make noise when the appliance is running.
• During the drying cycle, the tumble dryer creates an airflow that makes a noise when it is hitting the drum.
OTHER FAILURE
Display
LEDs "Less" and "Standard" flashing. Damaged temperature sensor or PCB failure.
Extra LED flashing.

8/ WARRANTY AND LIMITATIONS OF LIABILITY

This product is guaranteed for a period of 24 months (defined by local law) from the date of purchase against any failure
resulting from manufacturing or material defects.
This warranty does not cover damage caused by improper installation, improper use, or normal wear and tear of the product.
More specifically, the warranty does not cover:
-
Damage or problems caused by improper use, accident, alteration or electrical connection of improper intensity or voltage.
-
Modified products, those whose warranty seal or serial number have been damaged, altered, removed or oxidized.
-
Replaceable batteries and accessories are guaranteed for a period of 6 months.
-
Failure of the battery due to overcharging or failure to observe the safety instructions explained in the instruction manual.
-
Cosmetic damage, including scratches, dents, or any other element.
-
Damage caused by any intervention carried out by an unauthorised person.
-
Defects caused by normal wear and tear or due to normal ageing of the product.
-
Software updates due to a change in network settings.
-
Product failures due to the use of third party software to modify, change or adapt the existing software.
-
Product failures caused by use without accessories approved by the manufacturer.
-
Oxidised products.
Under no circumstances can the manufacturer be responsible for the loss of data stored on the disk. Similarly, the manufacturer
is not required to verify that the SIM/SD cards are removed from the returned products.
Repaired or replaced products may include new and/or reconditioned components and equipment.
Possible cause
The power is cut off.
The power plug is not fully inserted. Check the power socket and make sure the plug is firmly
The tumble dryer is overloaded.
The temperature fuse has blown.
The lint filter is clogged.
The inlet or exhaust duct is clogged. Clean the exhaust duct.
The tumble dryer is overloaded.
Clothes are not removed in time
after completion.
Clothes are not sorted properly.
The selected temperature is too
high.
Laundry is over-dried.
Laundry is sensitive to rubbing.
Possible cause
Temperature sensor is short-circuited or PCB error.
Wait for the power to be restored.
inserted.
Clothes must be spun and the load to be dried must not
exceed the rated capacity (7 kg weight of dry laundry).
Restore temperature fuse.
Clean the lint filter after each cycle.
Do not exceed rated capacity (7 kg weight of dry laundry).
Remove clothes immediately after the end of the
programme.
Observe the care label on clothes.
Observe the care label on clothes.
If clothes are sensitive to shrinkage, check the clothes
after they are dry. Take out the clothes when damp.
Then hang the clothes until they are completely dry.
Use fabric softener to lubricate the fibres, sprinkle
laundry starch on the cuffs and neckline while ironing the
garments. Turn the laundry inside out to avoid pilling.
If there is a problem, contact your
local service centre.
10
Remedy
Remedy