Replacing The Edger Blade; Storing The Product; High Altitude Engine Operation - Black Max BM25CSEDG Manual Del Operador

REPLACING THE EDGER BLADE

See Figures 22 - 24.
Replace blades when worn down to indicator hole on blade.
Use replacement blade model number AC04215.
 Stop the engine and disconnect the spark plug wire.
 Align the slot in the flange washer and gear case with the
slot in the flange; place the holding pin through all three
slots to secure in place.
 Using a 1/2 in. socket wrench, turn the blade nut clock-
wise to loosen.
 Remove the old blade from the edger shaft.
 Clean debris from the edger shaft and flange washers.
 Center the new blade on the flange washer, making sure
the blade sits flat.
 Install the cupped washer with the hole off of the blade
surface.
 Install the blade nut onto the edger shaft.
 Using a 1/2 inch socket wrench, turn the blade nut coun-
terclockwise onto the edger shaft and tighten securely.
 This replacement part is available from the place of pur-
chase, or by calling customer service.
NOTE: Always make sure the blade is correctly installed
and securely fastened before each use.
ATTACHING THE STORAGE HANGER
See Figure 25.
There are two ways to hang the attachment for storage.
 To use the hanger cap, push in the button and place the
hanger cap over the end of the attachment shaft. Slightly
rotate the cap from side to side until the button locks into
place.
 The secondary hole in the attachment shaft can be used
for hanging purposes as well.
This product has a Three-year Limited Warranty for personal, family,
or household use (30 days for business or commercial use).
For warranty details, visit www.blackmaxtools.com
MAINTENANCE
or call (toll free) 1-800-726-5760.
Page 12 — English

STORING THE PRODUCT

 Clean all foreign material from the product. Store idle unit
indoors in a dry, well-ventilated area that is inaccessible
to children. Keep away from corrosive agents such as
garden chemicals and de-icing salts.
 Abide by all ISO and local regulations for the safe storage
and handling of gasoline.
When storing 1 month or longer:
 Drain all fuel from tank into a container approved for
gasoline. Run engine until it stops.

HIGH ALTITUDE ENGINE OPERATION

Your engine is configured for operation below 2000 feet
altitude at the factory. Your engine must be re-configured
for operation above 2000 feet altitude. Operating the engine
with the wrong engine configuration at a given altitude may
increase its emissions, decrease fuel efficiency, degrade per-
formance and cause irreversible damage. Engines configured
for high altitude operation cannot be operated in standard
altitude conditions. A qualified service center should ensure
that your engine is properly configured for your location.