Identification Plate; Before Commissioning; Assembly Of Components - Smeg HMF01 Manual De Uso

Description / Assembly / Commands
DESCRIPTION OF THE
APPLIANCE (Fig.A)
1 Accessory slots
2 Handle
3 Accessory release trigger
4 Speed and timer display
5 Start/Stop button
6 Speed adjustment buttons
7 Optimus beaters
8 Dough hooks
9 Wire beaters
10 Accessory bag
11 Feet

12 Identification plate

13 Cable winding clamp
IDENTIFICATION PLATE (12)
The identification plate states the technical
data, the serial number and marking. The
identification plate must never be removed.

BEFORE COMMISSIONING

• Unpack the appliance carefully and remove
all packaging materials and any labels and
stickers.
• Clean the motor base using a damp cloth.
Wash all components and dry thoroughly
(see paragraph "Cleaning and Mainte-
nance").
Before use, check that all compo-
nents are integral.

ASSEMBLY OF COMPONENTS

(Fig. B)
• Beaters and dough hooks must be inserted
into the correct side, and are not inter-
changeable.
• Insert beater/dough hook with a round
ring (A) into the round slot (A).
• Insert beater/dough hook with octagonal
ring (B) into the octagonal slot (B).
EN - 4
Do not use two accessories of
different type together.
DESCRIPTION OF CONTROLS
AND ACCESSORIES
The appliance is equipped with 3 buttons and
a time and speed display.
Display (4)
(4a)
Selected speed
Buttons
(5)
ON - OFF Key
(6)
Decrease speed
Optimus beaters (7)
• Use this accessory for semi-hard doughs,
medium-consistency creams, chocolate
based doughs, pastry doughs, cakes and
biscuits doughs,etc.
• Always use both beaters.
(4b)
R u n n i n g t i m e r i n
minutes
R u n n i n g t i m e r i n
seconds
Increase speed/
Turbo function
(keep pressed)