Tabla de contenido
Publicidad
Operation
(cont.)
To make sure that the repeater learns a control correctly, the blinking of the installation LED is noted for each RF message.
PROBLEM
The Learn indicator light comes on for
5 seconds.
The Learn indicator light comes on for
10 seconds.
The Learn indicator light no longer
blinks during learning.
During learning, pressing the
programmed control key does not make
the Learn indicator light blink rapidly.
When the scenario is saved, the Learn
indicator lights of certain receivers do
not go out.
CAUSE
Learning is impossible.
The number of memorised transmitters
is greater than 32.
The learning mode closes after 10
minutes (with no action).
After pressing the Learn button once,
function key learning must be done
within the following minute.
Poor communication between prod-
ucts.produits.
14
SOLUTION
Install compatible products.
Delete unused scenarios.
Start learning again.
Start learning again.
Reduce the distance between the
transmitter and the receivers(s), then
start learning again or add a repeater.
Publicidad
Tabla de contenido
