Operation
Choice of the position of the RF/ RF// switch:
It is advisable to leave the switch on RF// by default; this means that the radio messages are transmitted to the product's
two aerials and improves the radiofrequency range between the repeater and the associated receivers.
However, in installations with numerous transmitters (>20), where a large number of radio messages can be transmitted at
the same time, it is advisable to reduce the number of these messages by moving the switch to RF/. This means that the
radio messages will only be sent to one of the two aerials.
The "In One by Legrand" RF repeater is used when the transmitter and
the radio receiver are too far apart for them to be able to communicate
with each other.
Operation of the installation with one repeater
Operation of the installation with two repeaters
Repeater 1
L
N
4
Repeater 2