Tommee Tippee easiwarm Instrucciones De Uso

EN | IMPORTANT SAFEGUARDS
READ ALL INSTRUCTIONS
FOR HOUSEHOLD USE ONLY
When using electrical appliances, basic safety precautions should always
be followed including the following:
• Do not touch hot surfaces, use handles and knobs.
• Always use on a flat heat resistant surface.
• To ensure continued protection against risk of electric shock, connect
to properly grounded outlets only.
• To protect against fire, electric shock and injury to persons do not immerse
cord, plugs or other parts of the unit in water or other liquid.
• When in use the food and bottle warmer contains hot water and steam.
• Extreme caution must be used when moving an appliance containing hot oil
or other hot liquids.
• Always keep the food and bottle warmer and it's plug out of reach of small
children.
• Before plugging in the food and bottle warmer for the first time ensure the
voltage is compatible with your electricity supply by checking the label on
the base of the unit.
• Ensure water has been added to the unit before switching the unit on.
• The product has been fitted with a cord wind on the base of the unit to allow
you to adjust the length of the cord safely. It is recommended that the cord be
kept as short as possible.
• User maintenance other than cleaning or descaling is not required for this
product.
• This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety. Children shall not
play with this appliance.
• Do not place on or near a hot gas or electric burner or in a heated oven.
• Close supervision is necessary when any appliance is used by or near children.
• Unplug from outlet when not in use and before cleaning. Allow to cool before
putting on or taking off parts and before cleaning the appliance.
• Do not operate any appliance with a damaged cord or plug or after the
appliance malfunctions or has been damaged in any manner. Return appliance
to the nearest authorized service facility for examination, repair or adjustment.
• The use of accessory attachment is not recommended by the appliance
manufacturer as this may result in fire, electric shock or injury to persons.
• Do not use outdoors.
• Do not let cord hang over edge of table or counter or touch hot surfaces.
• Always attach the plug to the unit first, and then plug into the wall outlet.
To disconnect turn any control "off" then remove the plug from the wall outlet.
• Do not use appliance for anything other than intended use.
• Before serving, unplug cord from wall outlet and dish. Do not leave cord within
child's reach.
• Always place the bottle or food jar into the warmer before adding the water.
• Ensure that the heating guidelines are followed to ensure that the food is not
heated for too long.
• When the milk or food has reached the desired temperature, remove
immediately. If left in the warmer the temperature of the milk or food will
continue to increase.
• Before serving be sure food is at safe temperature.
• Do not move appliance when in use.
• A short power-supply cord is provided to reduce the risks resulting from
becoming entangled in or tripping over a longer cord.
• Extension cords (or longer detachable power-supply cords) are available and
may be used if care is exercised in their use.
• If an extension cord is used:
• The marked electrical rating of the extension cord should be at least
as great as the electrical rating of the appliance;
• If the appliance is of the grounded type, the extension cord should be a
groundingtype 3-wire cord; and
• The longer cord should be arranged so that it will not drape over the
countertop or tabletop where it can be tripped over, snagged, or pulled
on unintentionally (especially by children).
SAVE THESE INSTRUCTIONS
USAGE
The speed at which the food and bottle warmer heats the milk or food will depend on the size of the
bottle or container and the starting temperature of the milk or food (e.g. room temperature 70°F or from
the refrigerator 40˚F). We recommend that setting is always used for heating up, setting
keeping warm only. Setting is a MIN setting and should not be used. MILK OR FOOD SHOULD NOT BE
HEATED FOR OVER 30 MINUTES. The guide gives an indication of the time you can expect the warmer to
take. Maximum average stabilised temperature is approximately 185 °F
FOR FEEDING BOTTLES
1. Place filled bottle in the food and bottle warmer.
2. Fill the food and bottle warmer with water to the inside edge using a jug or bottle (unless using a 5 oz
bottle). For a smaller bottle fill to the underside of the screw ring. Never let the water overflow or rise
above the neck of the bottle.
3. Before plugging in, make sure the food and bottle warmer is switched to the setting. Ensure your hands
are dry.
4. Plug in the unit to the mains and switch the mains on.
5. Turn dial to setting . The amber light will turn on to indicate the food and bottle warmer is switched on
and is heating up.
6. Once the water is heated, the amber light will switch off to indicate that the thermostat will maintain the
temperature of the water. It does not indicate that the milk is ready. Please refer to the timings table in
this manual to find out how long the milk should be heated for.
7. Heat the milk to the desired temperature. Ensure that the heating guidelines are followed to ensure that
the milk is not heated for too long.
8. Take care when removing the bottle, as it and the surrounding water will be hot.
9. For your child's safety always check milk temperature before feeding by testing on a sensitive part of
your skin.
Take care not to overheat the milk. Gently agitate the bottle prior to feeding.
10. During feeds the bottle can be placed back in the warmer to keep milk warm by using setting .
The thermostat will maintain the temperature of the water. In doing this the indicator light will switch
to amber to indicate the warmer is heating up.
11. Turn back the dial to setting and unplug the unit after feeding.
12. Empty the unit of any water and wipe dry.
FOR BABY JARS
1. Remove the lid and place jar in the food and bottle warmer.
2. Fill the food and bottle warmer with water to the inside edge using a jug or bottle. Ensure the water level
is lower than the rim of the jar.
3. Before plugging in, make sure the food and bottle warmer is switched to the setting .
4. Plug in the unit to the mains and switch the mains on.
5. Turn dial to setting to heat up food. The amber light will turn on to indicate the food and bottle warmer
is switched on and is heating up.
6. Once the water is heated, the amber light will switch off to indicate that the thermostat will maintain the
temperature of the water. It does not indicate that the food is ready. To ensure that the food stays at the
temperature you have selected, the thermostat will maintain the temperature of the water. In doing this
the indicator light may switch to amber whilst you are heating the food.
7. Heat food to the desired temperature. Ensure that the heating guidelines are followed to ensure that the
food is not heated for too long. Please refer to table provided in this leaflet.
8. Take care when removing the jar, as the surrounding water will be hot.
9. For your child's safety – Always check food temperature before feeding by testing on a sensitive part
of your skin. Take care not to overheat the food.
10. During feeds the jar can be placed back in the food and bottle warmer to keep food warm by using
setting . The thermostat will maintain the temperature of the water. In doing this the indicator light will
switch to amber to indicate the warmer is heating up.
11. Turn back the dial to setting and unplug the unit after feeding.
12. Empty the unit of any water and wipe dry.
HEATING GUIDELINES
INITIAL
TEMPERATURE
OF FOOD
5oz (150ml) 9oz (260ml) 12oz (340ml)
tommee tippee tommee tippee tommee tippee
closer to nature bottle closer to nature bottle closer to nature bottle
SETTING
setting 3 setting 3 setting 3
FROM FRIDGE
5 minutes 8 minutes 10.5 minutes
40˚F (5˚C)
ROOM TEMP
4 minutes 6 minutes 8 minutes
70˚F (20˚C)
CLEANING
Unplug and allow to cool before cleaning. After each use pour away remaining water from the food and
bottle warmer base by the tipping the food and bottle warmer sideways over a sink and wipe clean with a
damp cloth only. Do not clean with abrasive cleaners or allow to come into contact with solvents or harsh
chemicals, damage could result.
DE-SCALING
The frequency of de-scaling should be as follows:
Hard water – 7 days
Medium – 14 days
Soft – 21 days
You can find out your water quality via your water provider. Unplug the food and bottle warmer and allow
to cool before cleaning. After each use pour away remaining water from the food and bottle warmer base
by the tipping the food and bottle warmer sideways over a sink and wipe clean with a damp cloth only. A
build up of limescale can negatively affect the performance of the food and bottle warmer. We recommend
carrying out the descaling process as per above frequency guidelines to ensure the food and bottle warmer
continues to work efficiently. Living in a hard water area can produce limescale quicker than other areas
therefore descaling is required sooner. Use a descaler that is suitable for use with stainless steel and use as
per the manufacturer's guidelines. Alternatively you can use white vinegar to descale your food and bottle
warmer, please use as per manufacturer's guidelines. Once you have descaled then perform a final cleaning
cycle. You may need to repeat the process if you find that limescale is still present. DO NOT use metal
objects or scourers to clean your food and bottle warmer. DO NOT use bleach to clean the food and bottle
warmer. DO NOT use abrasive or anti-bacterial materials.
is used for
food jar
4oz (113g)
setting 3
16 minutes
13 minutes
easiwarm
bottle and food warmer
calentador para biberones
y alimentos
chauffe-aliments/biberon
instructions for use
mode d'emploi
instrucciones de uso
Please read and keep these instructions
Veuillez lire et conserver ces instructions
Lea y conserve estas instrucciones