Explanation Of Warning Symbols - Lorentz S1-200 Manual Del Usuario

Sistema de bombeo solar
Ocultar thumbs Ver también para S1-200:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

EN
Controller input
max. input voltage (Voc)
55 V DC
Operating voltage
16...55 V DC
max. current (DC)
6 A
max. pv short circuit current
25 A
(Isc)
Controller output
Output voltage
max. 55 V
BLDC PWM
3-Phase
Frequency
max. 170 Hz
max. continuous current
6 A
max. continuous power
250 W
Case
IP class
IP 68
Protective class
Protective
class II
General
Ambient Temperature
-40... +50 °C
Environmental category
Outdoor
Wet location classification
Yes
Pollution degree
PD3
classification
max. altitude rating
max. 2000m
Overvoltage category
OC II
input/output
l

Explanation of warning symbols


WARNING
– Disregard can lead
to injury, death or damage the
system
The
WEEE Symbol means that
a device must be disposed of
separately from general household
waste. When a device reaches
the end of its lifespan, it must
be taken to a designated waste
collection point for safe disposal or
recycling.
l
When installing and using this electrical
equipment, basic safety precautions should
always be followed, including the following:
WARNING
– To reduce the risk of
injury, do not permit children to
use this product unless they are
closely supervised at all times
WARNING
– To reduce the risk of
electric shock, replace damaged
cords immediately
WARNING
- Due to local laws an
external fuse might be necessary
WARNING
– When the
photovoltaic array is exposed to
light, it supplies a DC voltage to
the controller
WARNING
- Make sure that the
controller is unplugged when
installing the pump system
Keep pump out of direct sun during installation
l
to avoid overheating.
We recommend to use only one extension
cable. Using multiple extension cables will
reduce system performance.
WARNING
- Do not try to open
the controller. This will damage
the controller and voids the
waranty
WARNING
- Only connect
equipment that was provided by
the manufacturer or supplier to
this pump
Ensure the pump class is suitable for the water
temperature.
PE S1-HR-XX-X-PASN-FNXX-HA
Pump end type:
07
14
23
Temperature
Water temperature range
class
2
+20 – +30 °C (68 – 86 °F)
3
+30 – +40 °C (86 – 104 °F)
4
+40 – +50 °C (104 – 122 °F)
Temperature class:
2
3
4

Publicidad

Tabla de contenido
loading

Tabla de contenido