Introduction; Device Description (Fig. 1); Scope Of Delivery; Proper Use - Scheppach HC85V Traducción Del Manual De Instrucciones Original

1.

Introduction

Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer
We hope your new tool brings you much enjoyment and
success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this device assumes no liability for
damage to the device or caused by the device arising
from:
• Improper handling
• Failure to comply with the operating manual,
• Repairs carried out by third parties, unauthorised
specialists
• Installing and replacing non-original spare parts,
• Improper use
• Failures of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
57113 / VDE 0113 not being observed
Note:
Read the whole text of the operating manual before as-
sembly and commissioning.
This operating manual should help you to familiarise
yourself with your device and to use it for its intended
purpose.
The operating manual includes important instructions
for safe, proper and economic operation of the device,
for avoiding danger, for minimising repair costs and
downtimes, and for increasing the reliability and ex-
tending the service life of the device.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the device in your country.
Keep the operating manual at the device, in a plastic
sleeve, protected from dirt and moisture. They must be
read and carefully observed by all operating personnel
before starting the work.
The device may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards.
The required minimum age must be observed.
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such machines must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.

2. Device description (Fig. 1)

1. Transport handle
2. Cable
3. Pressure vessel
4. Wheel
5. Foot
6. Cable holder
7. Pressure regulator
Air filter
8.
9. Quick coupling
10. Drain screw for condensate
11. On/off switch
12. Pressure gauge (vessel pressure can be read off)
13. Manometer (set pressure can be read off)
14. Safety valve
A. Rubber cover for supporting feet
B. Split pin
C. Wheel axle

3. Scope of delivery

1x compressor
2x feet (4)
2x wheels (5)
2x Rubber cover for supporting feet (A)
2x Cotter pin (B)
2x wheel axle (C)
Operating manual

4. Proper use

The compressor is used to generate compressed air
for pneumatically powered tools that can be operated
with an air rate of up to 170 l/min. (e.g. tyre inflaters,
air blow guns, paint spray guns). Due to the limited air
flow rate, it is not possible to operate tools with a very
high compressed air consumption (e.g. orbital sanders,
straight grinders and impact screwdriver).
The machine may only be used in the intended manner.
www.scheppach.com
GB | 19