LaserLiner AirBreeze 120 Manual De Instrucciones página 14

1
Correct setup of the air purifier
Ensure the purifier is positioned at least 50 cm to the
side and 10 cm to the rear away from adjacent objects
and electrical devices. The performance of radios and
televisions can be negatively affected if their mains plug
is plugged into the same socket strip as the air purifier's
mains plug. Use a separate power source for this reason.
To ensure perfect operation, do not cover the air purifier
or build constructions above it.
2
Operation
Insert the mains plug into the socket. A short beep sounds
and all the displays flash twice. The Stand-by display then
lights up red. Pressing the ON/OFF button (b) switches the
device to automatic mode.
3
Functions
Adjusting the fan speed
Four fan speeds are available, from 'Low', ➝ 'Medium' ➝ 'High' ➝ 'Sleep' and then back to the start
of the sequence. In Sleep mode, the device operates particularly quietly (20 dB (A)) and the control panel
is dimmed. Press the fan speed symbol to switch Sleep mode on and off.
Filter reset button
When switched on, the air purifier counts down. When you switch the device off and start it again, the
countdown continues. A beep indicates that the filter must be replaced after 2000 hours and the Change
filter light flashes. Press the Filter reset symbol (c) for 3 seconds after changing the filter. The pictogram
light up fully, stops flashing, and the beep ceases.
Set timer
You can use the timer function to set the device to switch off after 1, 2, 3 or 8 hours. Press the 'Time'
symbol until you reach the required setting.
Child lock
Press the lock symbol (d) for 3 seconds to activate the child lock. The child lock is off when the symbol
is continuously lit and on when the symbol flashes..
14
EN
50 cm