BUILT-IN GAS HOB WITH GLASS LID ▪
INSTALLATION ON SUPPORT STRUCTURE
The appliance must be mounted on a support structure, made of fire-retardant and heat-resistant material
and with all of the sturdiness requirements indicated by the technical sector standards (for example EN14749).
The work surface must be perfectly horizontal and perpendicular to all surrounding vertical panelling. The
area near the appliance could get very hot. Pay the utmost attention and do not place sockets, other
household appliances, power cables, piping and any other heat-sensitive or flammable material in this area.
CAUTION!
The appliance must be installed in a room without air draughts which can have a negative
effect on combustion. The chosen installation position must also prevent the accumulation of
unburnt gases.
Comply with the sizes indicated in this manual. Any deviation could cause the temperature to rise excessively.
The surrounding surfaces must be able to withstand temperature rises admitted by standard EN30-1-1
and in compliance with the design of this unit. All combustible materials, such as curtains and shelves,
must be kept far away from the appliance. Check the admissible temperature of the materials used for the
surrounding surfaces to guarantee their compliance with the requirements of EN30-1-1.
RECESSED HOLE
The support structure must be provided with a suitable recessed hole. Refer to the following table for the
adequate hole size for the purchased model and match the information with the drawings in the technical
data sheets provided for each model in the first part of this manual.
model
FC1346
FC1346-E-TR
SAFETY DISTANCES
The appliance must be kept a certain distance away from side walls, the rear panel and the cabinets. Consult
the following table:
dimensions and minimum safety distances for installation
model
a min
b min
[mm]
[mm]
50
100
FC1346
50
100
FC1346-
E-TR
If the appliance is recessed above an oven or another
powered home appliance, a separation panel must
also be installed as indicated in point 1.
Remember to prepare adequate holes in the furniture
to pass through the gas, water and electrical power
pipes of the appliance, if any.
CAUTION!
Protect the bottom of the equipment from
impacts and contact with drawers and
kitchen equipment in the compartments
below.
46
recessed hole sizes
[mm]
[mm]
a
b
440
320
440
320
c min
d min
e min
[mm]
[mm]
[mm]
440 +
650
110
(2xB)
440 +
650
110
(2xB)
FC1346 series
[mm]
c
R 25
R 25
C
B
A
1
[mm]
d
R 70
R 70
D
D
max
150 mm
E