CAN FC1346 Manual De Instrucciones página 55

OFF
MAX
MIN
LIGHTING THE BURNERS
CAUTION!
Before use, make sure that the burner spreaders, caps and pan holders are positioned properly.
The matching burner is indicated on each knob.
The burner can be lit:
▪
manually using the external igniter (on S versions),
▪
piezoelectrically with mechanically/manually operated piezoelectric igniter (on P versions).
▪
electronically using the push-button and the spark generator (on E versions).
Proceed as follows to light the burner:
step
1 Press the knob corresponding to the burner you want to light all the way and turn it anticlockwise (to the
maximum symbol).
2 At the same time, push the ignition button located between the knobs of the gas valves all the way; the spark
generator will release a series of repeated pulses that will ignite the flame.
3 When lit, keep the knob pressed all the way for another 5 seconds (at maximum) and then release it, adjusting
the desired intensity of the flame.
Please note: this delay in releasing the knob heats up the safety thermocouple.
If the burner does not remain lit when you release the knob, it means that the thermocouple did not heat
up sufficiently. To solve this problem, repeat the operations described in the table, holding the knob down
longer after the burner is lit.
use of burners
burner spreader positioning
1/2
Installation, use and maintenance instruction manual
( )
3
from max to min
action
( )
3
from min to max
▪
Ed. 01/2021 Rev. 01
55