Main Unit; Radio Controlled Clock - Techno Line WS8007 Manual De Instrucciones

Part B:
B1: "MODE" button
B2: "SNOOZE" button
B3: "ALARM" button
Part C:
C1: Wall Mount Hole
C2: Battery Compartment
3. Getting Started:

3.1 Main Unit:

 Slide open battery compartment cover [C2]
Insert 4 x AA size batteries observing polarity ["+" and" –" marks].

 Replace battery compartment cover [C2]
 Use a pin to press the RESET [B6] button on the rear of unit, the unit is now ready for
use.
4. Time and Alarm Setting

4.1 Radio Controlled Clock:

 After batteries inserted, the clock automatically starts to scan the DCF time signal. Radio
Control Icon" " flashes on the LCD.
flashes,
Indicating now is receiving
DCF signal
 The clock automatically scans the time signal at 3.00 a.m. every day to maintain accurate
timing. If reception fail, scanning stops ("
4.00 a.m. 5.00a.m. and6.00a.m.
The clock can be set to scan the time signal manually by holding "

seconds. Each reception takes about 5 minutes. If receptions fail, scanning stops. ("
on LCD disappear) and repeats again on next full hour. E.g. scanning failed at 8:20a.m. It
will scan again at 9:00a.m.
Stop scanning by holding "

"DST" shown on the LCD if it is in Daylight Saving Time Mode

Note: Buttons will not function while scanning for DCF time signal unless they are well
received or stopped manually.
B4: "+/12/24" button
B5: "-/C/F/
B6: "RESET" button
C3: Stand
turns on,
Indicating signal received
successfully
" on LCD disappear) and repeats again at
" button (B5) for 3 seconds.
GB 2
" button
disappear,
Indicating signal reception
failed
" button (B5) for 3
"