Tabla de contenido
Publicidad
Department of Communications.
NOTICE: Changes or modifications made to this device not expressly approved by Signify North America
Corporation (USA) and Signify Canada Ltd/Signify Canada uee. (Canada) (collectively
"Signify")
may void the U.S.
FCC and Canadian authorization to operate this
device,
The advanced interface module complies with FCC radiation
exposure limits set forth for an uncontrolled environment. This device should be installed and operated with a
minimum distance of 20 centimeters between the radiator and your body The manufacturer is not responsible for
any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void
the user's authority to operate the equipment. However, there is no guarantee that interference will not occur in a
particular installation If this device does cause harmful interference to radio or television reception, which can be
determined by turning the device off and on, the user is encouraged to try to correct the interference by one or more
of the following measures: Reorient or relocate the receiving antenna.
•
Increase the separation between the device
and receiver.
•
Connect the device into an outlet on a circuit different from that to which the receiver is connected •
Consult the dealer or an experienced radio/television technician for help.
Wireless
Specification: Wireless RF mode frequency band: 2400-2483.5 MHz
·
Wireless communications protocol:
IEEE 802.15.4 • Operating channels Zigbee: channels 11- 26 • Operating channels Bluetooth: channels 0-39
LIMITED
WARRANTY: Signify warrants that this device's hardware components will be free from defects in material
and workmanship for a period of two (2) years from the date of purchase, unless a different period is stated in or on
the packaging of the product, based on up to 3 hours average working time per day/7 days per week, when used as
directed (the
"Warranty
Period"). Notwithstanding the foregoing, the Warranty Period for all Energy Star-certified
products is three (3) years from the date of purchase. This limited warranty only applies to the hardware
components contained in the original packaging. This limited warranty does not apply to any software, even if
packaged or sold with the hardware components. Signify does not warrant that use of this device will be
uninterrupted or error-free. If this device does not conform to this limited warranty, Signify will send you, at its
election, a replacement device or refund your original price upon receipt of the returned device, register receipt and
proof of purchase. Please call our toll-free number, 1-800-555-0050, or write to us (address indicated on the
packaging) to find out how to return the device. This limited warranty does not cover devices subject to accident,
neglect, abuse, misuse or acts of God. REPLACEMENT OR REFUND IS YOUR SOLE REMEDY. EXCEPT TO THE
EXTENT PROH IBITED BY APPLICABLE LAW, ANY IMPLIED WARRANTIES ARE LIMITED IN DURATION TO THE
DURATION OF THIS LIMITED WARRANTY LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES IS HEREBY
EXPRESSELY EXCLUDED. Some states and provinces do not allow exclusion of incidental or consequential
damages, so the above limitation or exclusion may not apply to you. This limited warranty gives you specific legal
rights, and you may also have other rights which vary from state to state and province to province. This limited
warranty is subject to, and may be superseded by, our End of Support policy to the extent Signify decides to
terminate support for this device in accordance with its End of Support policy, available here:
www.philips-hue.com/endofsupportpolicy
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. Alterations in design and
technical specifications reserved.
FR - CONSIGNES DES
stcuRITE -
PARTIE B
Le fabricant decrit l'usage approprte des luminalres (apparells d'edairage)! Par consequent, suivez toujours ces
directives pour assurer une Installation adequate et securitaire, ainsi que le bon fonctionnement du luminaire, et
conservez-les pour reference ulterieure. Coupez l'alimentation electrique au boitier de fusibles ou de disjoncteurs
principaux avant de commencer ['installation, l'entretien ou la reparation. En cas de toute, consultez un electricien
qualifie ou communiquez avec votre detaillant. Assurez-vous de toujours installer le luminaire conformement au
code electrique en vigueur dans votre localite. Certaines reglementations exigent que les luminaires soient installes
par un electricien qualifie. Observez la bonne couleur des fits avant l'installation: blanc (neutre), noir (alimente) et
vert ou fil de cuivre nu (masse). Ne raccordez pas ce luminaire
a
un systeme electrique sans mise
a
la terre.
AVERTISSEM
ENT: l'installation de cet appareil d'eclairage dans un systeme electrique non mis
a
la terre peut
permettre aux pieces de metal du luminaire de porter un courant electrique si l'un des fits ou l'une des connexions
se casse ou devient lache. Dans une telle situation, quiconque entrerait en contact avec le luminaire subirait un choc
electrique pouvant causer des blessures et m~me la mort. Utilisez toujours des serre-fils/connecteurs convenant au
calibre et au nombre de fits utilises.
MISE EN
GARDE: Assurez-vous qu'aucun brin de fit nu n'est expose
a
l'exterieur
des serre-fils/connexions (le cas echeant). Prenez soin de ne pas endommager ou couper la gaine isolante
(recouvrement) des fits pendant l'installation. Ne laissez pas les fils entrer en contact avec des rebords coupants.
N'enlevez pas les tampons d'isolation thermique. II s'en suivrait une augmentation de la temperature et un risque
d'incendie Nettoyez l'interieur de l'appareil d'eclairage avec un chiffon
a
depoussierer, n'utilisez pas d'abrasifs ou
de solvants. Evitez d'utiliser des liquides sur toutes les pieces electriques. Tenez toujours compte de toutes les
specifications techniques du luminaire. Verifiez les pictogrammes figurant sur !'etiquette d'identification du luminaire
ainsi que les pictogrammes presentes
a
la partie A de vos consignes de securite. ATTENTION: Vous trouverez
ci-dessous toutes les explications, precedees d'un numero de reference, relatives aux plctogrammes et aux
consignes de securite de la partie B. Les pictogrammes applicables
a
votre appareil d'eclairage sont presentes dans
les consignes de securite de la partie A.
1)
Ce produit doit ~tre installe
a
l'interieur seulement. 2) Ce produit convient
a
un usage exterieur. 3) Convient
uniquement aux endroits secs. 4) Convient aux endroits humides, 5) Convient aux endroits detrempes
Publicidad
Tabla de contenido
